Mitsubishi Evolution X. Manual — part 103
LIGHTING
TSB Revision
CHASSIS ELECTRICAL
54A-15
INTERIOR LIGHT
.
INTERIOR LIGHT DIMMER CONTROL FUNCTION (THE INITIAL CONDITION:
30 SECONDS)
When the interior light switch is set to the DOOR
position, ETACS-ECU controls the interior light as
follows.
1. When the ignition switch is OFF:
By opening any door, the light turns ON (100%),
and dims (50%) when the door is closed, then
and turns off after 30 seconds.
However, when the ignition switch is turned ON
or the door lock is operated, the lights turn off at
that time.
2. When the ignition switch is ON:
By opening any door, the light (100%) turns ON
and OFF when the door is closed.
3. When all doors are closed, and the ignition key is
removed
*
:
By removing the ignition key with all doors
closed, the light turns ON 50%, and turns off after
30 seconds. However, for the vehicles with
TC-SST, the light is not illuminated if the ignition
key is removed before the engine stops running
(approximately 1 second) since the ignition
switch was turned to the OFF position.
By inserting the ignition key again or operating
the door lock with the light lit, the lights turns off.
NOTE:
.
•
*
: For the vehicles with KOS, it is operated the
same way when the IG knob is turned to OFF or
when the emergency key is removed from the
key cylinder. However, for vehicles with TC-SST,
the light is turned off after approximately 1 sec-
ond (after engine stops running) since the IG
knob was turned OFF.
•
For the vehicles with the keyless entry system,
the delayed light-off time and the operation times
of the keyless entry interior light answer back can
be changed by the Customization Function
(Refer to
.
AC607917 AC
(All closed) OFF
(Any one open) ON
ON
OFF
Key removed
ACC
LOCK
UNLOCK
OFF
Door switch
(Unlock) OFF
(Lock) ON
Driver's door lock
actuator switch (lock switch)
Ignition switch
100%
0%
50%
Interior light brightness
Keyless entry
lock or unlock signal
30 seconds
30 seconds
LIGHTING
TSB Revision
CHASSIS ELECTRICAL
54A-16
INTERIOR LIGHT AUTOMATIC-SHUTOFF FUNCTION (THE INITIAL CONDITION: 30
MINUTES)
When an interior light such as the dome light [all inte-
rior lights connecting to the dome light fuse (the front
dome light, the rear dome light, and the ignition key
cylinder illumination lights)] is lit, but either one of the
conditions is met, the interior light is turned off auto-
matically for preventing the battery discharge caused
by the unattended operation or the door-ajar.
• After 30 minutes with the interior light lit while the
ignition switch is OFF, the light turns off automati-
cally.
• After 30 minutes with any door opened while the
ignition switch is OFF, the light turns off automati-
cally.
• After the auto-turn OFF, the interior light returns
to the illumination state when the doors are
opened/closed, keyless entry transmitter switch
is operated, or ignition switch is turned to ACC
position. After returning, the light turns OFF after
30 minutes, when the interior light auto turn off
condition is met.
NOTE: The interior light automatic shut-off time can
be adjusted by the Customization Function (Refer to
.
IGNITION KEY CYLINDER ILLUMINATION LIGHT CONTROL FUNCTION
The ETACS-ECU controls the ignition key cylinder
illumination light as described below.
• With the ignition switch OFF, the light is illumi-
nated when the driver's door is opened, and it is
turned off 30 seconds after the driver's door is
closed. However, the light is turned off if the igni-
tion switch is turned ON or doors are locked
within 30 seconds.
AC302243AC
ON
OFF
ACC
Ignition switch
(All closed) OFF
(Any one open) ON
Door switch
(Illuminated) ON
(Extinguished) OFF
Interior light
t: Within 30 minutes
T: 30 minutes
T
T
t
t
t
AC710753
T
T
T
T
AB
(Closed) OFF
(Opened) ON
ON
OFF
(Key removed) ON
(Key inserted) OFF
(Illuminated) ON
(Extinguished) OFF
Driver's seat door switch
UNLOCK
LOCK
Driver's seat door
Key reminder switch
Ignition key cylinder
illumination light output
Ignition switch
T: 30 seconds
LIGHTING
TSB Revision
CHASSIS ELECTRICAL
54A-17
• When the ignition key is removed from the igni-
tion key cylinder, the light illuminates for 30 sec-
onds.
*
However, for the vehicles with TC-SST, the
light is not illuminated if the ignition key is
removed before the engine stops running
(approximately 1 second) since the ignition
switch was turned to the OFF position.
NOTE:
*
: For the vehicles with KOS, it is operated
the same way when the steering lock is locked or
when the emergency key is removed from the key
cylinder.
CUSTOMIZATION FUNCTION
M2544300700374
By operating the ETACS system or MMCS of scan
tool MB991958, the following functions can be pro-
grammed. The programmed information is held even
when the battery is disconnected.
Adjustment
item (scan tool
MB991958
display)
Adjustment item
Adjusting contents
(scan tool MB991958
display)
Adjusting content
ACC power
auto cut
Time to ACC power
cut-off when the
ignition switch is in
the ACC position
Disable
No function (default)
30 min
30 minutes
60 min
60 minutes
Turn power
source
Adjustment of
turn-signal light
operation condition
ACC or IG1
Operable with ACC or ON position
IG1
Operable with ON position (default)
Comfort flasher With/without
comfort flasher
function
Disable
No function
Enable
With function (default)
Comfort flasher
switch time
Switch operation
time to activate the
comfort flasher
function
Normal
0.4 seconds (default)
Long
0.8 seconds
Hazard answer
back
Adjustment of the
number of keyless
hazard warning light
answer back
flashes
Lock:1, Unlock:2
LOCK: Flashes once, UNLOCK: Flashes
twice (default)
Lock:1, Unlock:0
LOCK: Flashes once, UNLOCK: No flash
Lock:0, Unlock:2
LOCK: No flash, UNLOCK: Flash twice
Lock:2, Unlock:1
LOCK: Flash twice, UNLOCK: Flash once
Lock:2, Unlock:0
LOCK: Flash twice, UNLOCK: No flash
Lock:0, Unlock:1
LOCK: No flash, UNLOCK: Flash once
Lock:0, Unlock:0
No function
Sensitivity for
auto light
Lighting control
sensor sensitivity
(illumination
intensity) <vehicles
with auto light>
Level 1(+)bright
High-high ambient brightness
Level 2
High ambient brightness
Level 3
Standard ambient brightness (default)
Level 4(
−)dark
Low ambient brightness
Level 5(
−)dark
Low-low ambient brightness
COMBINATION METER
TSB Revision
CHASSIS ELECTRICAL
54A-18
COMBINATION METER
GENERAL INFORMATION
M2545500200428
The combination meter offers the following advan-
tages.
• Speedometer and tachometer are arranged sepa-
rately on the cylindrical shaped panel, achieving
a sporty layout with which the zero position of
needle indicator is arranged directly downward.
Also, white is adopted for the needle color to
improve visibility.
• New font style that offers good visibility and
sporty feel has been adopted, and the color is
made to bright white that offers a good contrast
with the background matt black, securing excel-
lent visibility suitable for any driving condition
encountered during daytime and nighttime.
• With the tachometer, the needle movement is
made highly responsive to the engine speed.
• Multi information display has been adopted which
displays various information, such as the S-AWC
control level display, by the operation of multi
information meter switch.
• By switching the display color of multi information
display to red or yellow, the warning level is indi-
cated.
• The service reminder function has been adopted
which notifies the users of the next periodic
inspection timing using the driving distance and
elapsed time.
• By operating the rheostat switch, the brightness
of the meter and illumination can be adjusted in
eight steps.
• The layout has been simplified by displaying what
is required to meet the legislative requirements
with the indicator, and by displaying other things
with multi information display.
• A tone alarm is integrated in the combination
meter so that the alarm contents or the operation
status of switches can be checked with the tone
alarm sound.
• To assure the LCD display responsiveness and
brightness even under a low-temperature condi-
tion, the LCD heater has been adopted.
Dome light
delay timer with
door
Adjustment of
interior light delay
shutdown time
0 sec
0 second (no delay shutdown time)
7.5 sec
7.5 seconds
15 sec
15 seconds
30 sec
30 seconds (default)
60 sec
60 seconds
120 sec
120 seconds
180 sec
180 seconds
Headlight auto
cut customize
Adjustment of
headlight automatic
shutdown function
Disable
No function
Enable (C-spec.)
With function (default)
Interior light
auto cut timer
Adjustment of
interior light
automatic shutdown
function operation
time
Disable
No function
3 min
3 minutes
30 min
30 minutes (default)
60 min
60 minutes
Adjustment
item (scan tool
MB991958
display)
Adjustment item
Adjusting contents
(scan tool MB991958
display)
Adjusting content
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст