Mitsubishi Outlander XL. Manual — part 940
If DTC U0175 is set in the SRS-ECU, always
diagnose the CAN main bus line.
CIRCUIT OPERATION
If an impact of set value or more is detected, the side
impact sensor sends the coded acceleration data to
SRS-ECU. Based on the acceleration data, SRS-ECU
determines the necessity of side air bag and curtain
air bag deployment, and then turns ON the power
supply circuit to the inflator.
DTC SET CONDITIONS
These DTCs are set if communication between the
side impact sensor (front) (RH) and the SRS-ECU is
not possible or faulty.
TROUBLESHOOTING HINTS
⦆
Damaged wiring harnesses or connectors
⦆
Malfunction of the side impact sensor (front) (RH)
⦆
Malfunction of the SRS-ECU
DIAGNOSIS
Required Special Tools:
⦆
MB991958: Scan Tool (M.U.T.-III Sub Assembly)
⦆
MB991824: Vehicle Communication Interface (V.C.I.)
⦆
MB991827: M.U.T.-III USB Cable
⦆
MB991910: M.U.T.-III Main Harness A (Vehicles with
CAN communication system)
STEP 1. Using scan tool MB991958, diagnose the CAN bus
line.
ZC501967
AC404789
ZC5019680000
MB991824
MB991827
MB991910
Data link
connector
To prevent damage to scan tool MB991958, always turn the
ignition switch to the "LOCK" (OFF) position before
connecting or disconnecting scan tool MB991958.
(1)
Connect scan tool MB991958. Refer to "How to connect the
scan tool P.52B-31."
(2)
Turn the ignition switch to the "ON" position.
(3)
Diagnose the CAN bus line.
(4)
Turn the ignition switch to the "LOCK" (OFF) position.
Q:Is the CAN bus line found to be normal?
YES:
Go to Step 2.
NO:
Repair the CAN bus line (Refer to GROUP 54D,
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-291
SRS AIR BAG DIAGNOSIS
STEP 2. Recheck for diagnostic trouble code.
ZC501967
AC404789
ZC5019680000
MB991824
MB991827
MB991910
Data link
connector
Check again if the DTC is set.
(1)
Erase the DTC.
(2)
Turn the ignition switch to the "ON" position.
(3)
Check if the DTC is set.
(4)
Turn the ignition switch to the "LOCK" (OFF) position.
Q:Is the DTC set?
YES:
Go to Step 3.
NO:
There is an intermittent malfunction such as poor
engaged connector(s) or open circuit (Refer to GROUP 00,
How to Cope with Intermittent Malfunction P.00-15).
STEP 3. Check for any diagnostic trouble code. (Using scan
tool MB991958, read the diagnostic trouble code.)
Check the side impact sensor (front) (RH).
(1)
Disconnect the negative battery terminal.
(2)
Replace the side impact sensor (front) (RH) with the side
impact sensor (front) (LH).
(3)
Connect the negative battery terminal.
ZC501967
AC404789
ZC5019680000
MB991824
MB991827
MB991910
Data link
connector
(4)
Erase diagnostic trouble code from memory, and check the
diagnostic trouble code.
Q:Is DTC U0175 set?
YES:
Replace the side impact sensor (front) (RH) with a
new one. (Refer to P.52B-338). Go to Step 5.
NO:
Go to Step 4.
STEP 4. Check the harness wires for open circuit or short
circuit between SRS-ECU connector C-27 (terminal No.51
52B-292
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
SRS AIR BAG DIAGNOSIS
and 52) and side impact sensor (front) (RH) connector D-129
(terminal No.2 and 1).
Q:Are the harness wires between SRS-ECU connector C-27
(terminal No.51 and 52 and side impact sensor (front)
(RH) connector D-129 (terminal No.2 and 1) in good
condition?
YES:
Erase the diagnostic trouble code memory, and check
the diagnostic trouble code. If DTC U0175 sets, replace
the SRS-ECU (Refer to P.52B-326). Then go to Step 5.
NO:
Replace the harness wires between SRS-ECU connector
C-27 and side impact sensor (front) (RH) connector D-129.
Then go to Step 5.
STEP 5. Recheck for diagnostic trouble code.
ZC501967
AC404789
ZC5019680000
MB991824
MB991827
MB991910
Data link
connector
Check again if the DTC is set.
(1)
Erase the DTC.
(2)
Turn the ignition switch to the "ON" position.
(3)
Check if the DTC is set.
(4)
Turn the ignition switch to the "LOCK" (OFF) position.
Q:Is DTC U0175 set?
YES:
Return to Step 1.
NO:
The procedure is complete.
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-293
SRS AIR BAG DIAGNOSIS
DTC U0176: Side Impact Sensor (Rear) (RH) Communication Error
M15204000978USA0000010000
CPU
CPU
SIDE IMPACT
SENSOR
(FRONT: RH)
SIDE IMPACT
SENSOR
(REAR: RH)
SRS-ECU
Side Impact Sensor (Front, Rear) (RH) Circuit
ACCELERO
METER
ACCELERO
METER
ZC600876
Connector: C-27
C-27 (Y)
0025
ZC6008800017
Connector: D-132
D-132 (Y)
ZC6008790020
Connector: D-129
D-129 (Y)
52B-294
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
SRS AIR BAG DIAGNOSIS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст