Mitsubishi Outlander XL. Manual — part 1334
ETACS-ECU FUNCTIONS AND CONTROLS
M25400000120USA0000010002
THEFT-ALARM FUNCTION (DEFAULT: WITH FUNCTION)
ZC6010800000
Door(s) is locked by the keyless
entry system or the keyless operation system
when the ignition switch is in the OFF position
(including lock operation by the timer lock)
Alarm history
output function
System disarmed
Ready to be
armed suspended
Ready to be armed
Ready to be triggered
Interior protection
Exterior protection
Protection suspended
· Ignition switch (OFF )
· Rem oving the key from the key cylinder o r
the attestation of the keyless ope ration key is release d
· Simultaneous output (4 times) is complete
d
When a ny ope ration ab ove is don e
· Ignition switch (ACC)
· Inserting the key in the key cylinder
or keyless operation key is approved
· Previous alarm information exists
When all operations above are done
All doors and hood remain closed for 20 seconds
Door(s) or tailgate is opened by forced entry
In 10 seconds or 6 seconds
Hood is opened
All doors and hood
remains closed
for 2 seconds
In 180 seconds
Door(s) or tailgate is
opened by forced entry
In 175 seconds
or ignition switch is turned ON position
Operating the door lock with the keyless entry
transmitter or keyless operation key (except when
locked by the key cylinder or door lock switch) makes
the vehicle ready for the alarm, and a "ping" tone
starts. After 20 seconds, the incorrect door opening
(opening door or liftgate without unlocking by the
keyless entry) sounds the room alarm with "Beep"
tone under the alarm state. After 10 seconds, in
addition to the "Beep" tone, the headlight blink, and
the horn sounds intermittently for 175 seconds to
execute exterior protection. If the hood is opened
while the vehicle is under the alarm state or the interior
protection state, the exterior protection will be
executed immediately.
NOTE:
Availability of the theft-alarm and the
warning output can be adjusted by the
configuration function (Refer to P.54A-35).
54A-34
CHASSIS ELECTRICAL
THEFT-ALARM SYSTEM
ALARM HISTORY OUTPUT FUNCTION
If the interior protection or the exterior protection is activated
between the last OFF operation and the next ON operation of
the ignition switch, this function informs the driver by flashing the
theft-alarm indicator and by the tone alarm.
PANIC ALARM FUNCTION(DEFAULT: WITH FUNCTION)
With the ignition key removed from the ignition key
cylinder, when the panic button of transmitter is
pressed, the panic alarm is given off with flashing of
headlights and intermittent sounding of horn for 175
seconds.
NOTE:
Using the configuration function, the panic
alarm function can be enabled/disabled.(Refer
to P.54A-35)
CONFIGURATION FUNCTION
M25400000119USA0000010002
Using scan tool MB991958 adjusts the following
function. The programmed information is held even
when the battery is disconnected.
Adjustment
item
(scan
tool
MB991958 display)
Adjustment item
Adjusting contents (scan
tool MB991958 display)
Adjusting contents
Alarm
With/without
theft-alarm
function
Disable
Without function
Enable
With function (default)
Duration of pre-alarm Adjustment of pre-alarm
continue time
10 sec
10 seconds (default)
6 sec
6 seconds
Panic alarm switch
With/without panic alarm
function
Disable
Without function
Enable
With function (default)
CHASSIS ELECTRICAL
54A-35
THEFT-ALARM SYSTEM
MEMO
54A-36
CHASSIS ELECTRICAL
GROUP 54B
AUDIO AND NAVIGATION SYSTEM
CONTENTS
RADIO AND CD PLAYER. . .
GENERAL INFORMATION. . ....
SPEAKER. . . . . .
GENERAL INFORMATION. . ....
ANTENNA. . . . . .
GENERAL INFORMATION. . ....
MITSUBISHI MULTI COMMUNICATION
SYSTEM (MMCS). . . . ..
GENERAL. . . . . ....
REAR ENTERTAINMENT SYSTEM. ..
GENERAL. . . . . ....
54B-1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст