Mitsubishi Outlander XL. Manual — part 471
INSPECTION
M11703000049USA0000010000
EVAPORATIVE EMISSION VENTILATION
SOLENOID CHECK
ZC6044100000
Evaporative emission canister and
evaporetive emissionvent solenoid assembly
Nipple A
Nipple B
plug
Hand
vacuum
pump
1.
Connect a hand vacuum pump to nipple (A) of the evaporative
emission canistor and evaporative emission ventilation
solenoid assembly.
2.
Connect a plug to nipple (B) of the evaporative emission
canistor and evaporative emission ventilation solenoid
assembly.
ZC6024210000
Evaporative emission vent solenoid
3.
Check air tightness by applying a vacuum with voltage applied
directly from the battery to the evaporative emission
ventilation solenoid and without applying voltage.
Battery voltage
Normal condition
Applied
Vacuum maintained
Not applied
Vacuum leaks
ZC6024220000
Evaporative emission
vent solenoid
4.
Measure the resistance between the terminals of the solenoid.
Standard value: 17 - 21 Ω [at 20°C (68°F)]
CATALYTIC CONVERTER
GENERAL DESCRIPTION (CATALYTIC CONVERTER)
M11703000053USA0000010000
The three way catalytic converter, together with the
closed loop air-fuel ratio control based on the oxygen
sensor signal, oxidizes carbon monoxides (CO) and
hydrocarbons (HC), also reduces nitrogen oxides
(NOx).
When the mixture is controlled at stoichiometric air-
fuel ratio, the three way catalytic converter provides
the highest purification against the three constituents,
namely, CO, HC and NOx.
EMISSION CONTROL <MFI>
17c-19
CATALYTIC CONVERTER
MEMO
17c-20
EMISSION CONTROL <MFI>
GROUP 23A
AUTOMATIC TRANSAXLE
MECHANICAL
CONTENTS
GENERAL INFORMATION. . .
SPECIFICATIONS. . . ....
SERVICE SPECIFICATIONS. .
LUBRICANT. . . . . .
AUTOMATIC TRANSAXLE DIAGNOSIS
. . . . . . . ..
DIAGNOSTIC TROUBLESHOOTING FLOW
. . . . . . . ..
INTRODUCTION TO A/T DIAGNOSIS
. . . . . . . ..
A/T DIAGNOSTIC TROUBLESHOOTING
STRATEGY. . . . . ..
PRIMARY CHECK. . . . .
DIAGNOSTIC FUNCTION. . ...
HOW TO INITIALIZE A/T LEARNED VALUE
. . . . . . . ..
FAIL-SAFE/BACKUP FUNCTION. . . . .
ROAD TEST. . . . . .
TORQUE CONVERTER STALL TEST
. . . . . . . ..
HYDRAULIC PRESSURE TESTS. ..
DIAGNOSTIC TROUBLE CODE CHART
. . . . . . . ..
SYMPTOM CHART. . . . .
DIAGNOSTIC TROUBLE CODE PROCEDURES
. . . . . . . ..
DTC P0705: Transmission Range Switch
System. . . . . . ..
DTC P0712: Transmission Fluid
Temperature Sensor System (Short
Circuit). . . . . .
P0713: Transmission Fluid Temperature
Sensor System (Open Circuit).
DTC P0715: Input Shaft Speed Sensor
System. . . . . . ..
DTC P0720: Output Shaft Speed Sensor
System. . . . . . ..
DTC P0729, P0732,P0733, P0734, P0735:
6th, 2nd, 3rd, 4th, 5th Gear Ratio
. . . . . . . .
DTC P0731: 1st Gear Incorrect Ratio
. . . . . . . .
DTC P0736: Reverse Gear Incorrect
Ratio. . . . . . ...
DTC P0741: Torque Converter Clutch
System (Stuck Off), P0742 Torque
Converter Clutch System (Stuck ON)
. . . . . . . .
DTC P0743: Lock-up and Low-reverse
Brake Linear Solenoid Valve System
. . . . . . . .
DTC P0748: Line Pressure Linear
Solenoid Valve System. . ...
DTC P0753: Low Clutch Linear Solenoid
Valve System. . . . .
DTC P0758 2-6: Brake Linear Solenoid
Valve System. . . . .
23A-1
Continued on next page
DTC P0763: 3-5 Reverse Clutch Linear
Solenoid Valve System. . ...
DTC P0768: High Clutch Linear Solenoid
Valve System. . . . .
DTC P0815: Paddle Shift Switch (Up)
System. . . . . . ..
DTC P0816: Paddle Shift Switch (Down)
System. . . . . . ..
DTC P0826: Shift Switch Assembly
System. . . . . . ..
DTC P0841: Low Clutch Pressure Switch
System. . . . . . ..
DTC P0846: 2-6 Brake Pressure Switch
System. . . . . . ..
DTC P0871: 3-5 Reverse Clutch Pressure
Switch System. . . . ...
DTC P0876: High Clutch Pressure Switch
System. . . . . . ..
DTC P0893: Interlock Detection
. . . . . . . ...
DTC P0988: Low-Reverse Brake Pressure
Switch System. . . . ..
DTC P1705: Throttle Position Sensor
Information (Engine). . ...
DTC 1706: Accelerator Pedal Position
Information. . . . .
DTC P1731: 1st Engine Brake Detection
. . . . . . . ...
DTC P1753: Low Clutch Shift Solenoid
Valve System. . . . ...
DTC P1758: Low-Reverse Brake Shift
Solenoid Valve System. . ..
DTC P1773: ABS Information (ABS/ASC)
. . . . . . . ...
DTC P1794: Ground Return. ...
DTC U0001: Can Bus Off. . .
DTC U0100: ECM Time-out. .
DTC U0121: ABS/ASC-ECU Time Out
. . . . . . . ...
DTC U0141: ETACS-ECU Time Out
. . . . . . . ...
SYMPTOM PROCEDURES
<A/T>
. ..
INSPECTION PROCEDURE 1: The vehicle
does not run at any range. ..
INSPECTION PROCEDURE 2: The vehicle
does not run at the "D" or the "R"
range. . . . . . ..
INSPECTION PROCEDURE 3: The
acceleration is poor. . ...
INSPECTION PROCEDURE 4: The vehicle
moves at the "N" range. . .
INSPECTION PROCEDURE 5: Gears cannot be
shifted at all, or a certain gear shift
(1st to 2nd, 2nd to 3rd, etc.) is not
made. . . . . . ...
INSPECTION PROCEDURE 6: The torque
converter is not locked up. .
INSPECTION PROCEDURE 7: The clutch
slips when the vehicle starts or during
gear shift. . . . . .
INSPECTION PROCEDURE 8: The engine
brake is not applied. . ...
INSPECTION PROCEDURE 9: The shift shock
is large at a certain gear shift. (1st
to 2nd, 2nd to 3rd, etc.). ..
INSPECTION PROCEDURE 10: The select
shock is large when the transmission
range is shifted from "N" to "D", and
"N" to "R.". . . . . 23A-135
INSPECTION PROCEDURE 11: Abnormal
sound occurs during idling. .
INSPECTION PROCEDURE 12: Abnormal
sound occurs during driving.
INSPECTION PROCEDURE 13: Abnormal
sound occurs during gear shift.
. . . . . . . ...
INSPECTION PROCEDURE 14: Engine stall
. . . . . . . ...
INSPECTION PROCEDURE 15: Oil leaks from
the air breather. . . ...
INSPECTION PROCEDURE 16: The starter
does not rotate at the "P" or "N"
range. (The engine does not start.)
. . . . . . . ...
DATA LIST REFERENCE TABLE. . . .
TCM TERMINAL VOLTAGE REFERENCE CHART
FOR TRANSAXLE OPERATION. ..
SPECIAL TOOLS. . . .
23A-2
Continued on next page
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст