Mitsubishi Montero (2004+). Manual — part 560
VIDEO ENTERTAINMENT SYSTEM (VES)
TSB Revision
CHASSIS ELECTRICAL
54A-209
STEP 16. Measure at video controller unit connector F-34
in order to power supply circuit to video controller unit
(battery power supply).
(1) Disconnect video controller unit connector F-34, and
measure at the wiring harness side.
(2) Turn the ignition switch to "LOCK" (OFF) position.
(3) Measure the voltage between terminal 1 and ground.
• The voltage should measure approximately 12 volts
(battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery
positive voltage)?
YES : Go to Step 18.
NO : Go to step 17.
STEP 17. Check the wiring harness between video
controller unit connector F-34 (terminal 1) and fuse No.18.
AC309223
AC
CONNECTOR: F-34
HARNESS SIDE
AC209365JE
CONNECTOR F-34
(HARNESS SIDE)
AC309223
AC
CONNECTOR: F-34
HARNESS SIDE
VIDEO ENTERTAINMENT SYSTEM (VES)
TSB Revision
CHASSIS ELECTRICAL
54A-210
NOTE: Also check joint connector (7) D-02, intermediate con-
nector D-28 and D-125 for loose, corroded, or damaged termi-
nals, or terminals pushed back in the connector. If joint
connector (7) D-02 or intermediate connector D-28 and D-125
is damaged, repair or replace. Refer to GROUP 00E, Harness
Connector Inspection
.
Q: Is the wiring harness between video controller unit
connector F-34 (terminal 1) and the fuse No.18 in good
condition?
YES : Go to Step 18.
NO : Repair the wiring harness. The rear display works
normally.
STEP 18. Measure the resistance at video controller unit
connector F-34 in order to the ground circuit to the video
controller unit.
(1) Disconnect video controller unit connector F-34, and
measure at the wiring harness side.
(2) Measure the resistance value between terminal 11 and
ground.
• The resistance should be 2 ohm or less.
Q: Is the measured resistance 2 ohms or less?
YES : Go to Step 20.
NO : Go to Step 19.
AC309208
HARNESS SIDE
D-02
D-28, D-125
AE
CONNECTORS: D-02, D-28, D-125
D-02
D-28
D-125
AC309223
AC
CONNECTOR: F-34
HARNESS SIDE
AC209364
CONNECTOR F-34
(HARNESS SIDE)
KP
VIDEO ENTERTAINMENT SYSTEM (VES)
TSB Revision
CHASSIS ELECTRICAL
54A-211
STEP 19. Check the wiring harness between video
controller unit connector F-34 (terminal 11) and ground.
Q: Is the wiring harness between video controller unit
connector F-34 (terminal 11) and ground in good
condition?
YES : Go to Step 20.
NO : Repair the wiring harness. The rear display works
normally.
STEP 20. Check the video controller unit connector F-35
for loose, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Is the video controller unit connector F-35 in good
condition?
YES : Go to Step 21.
NO : Repair or replace the component(s). Refer to GROUP
00E, Harness Connector Inspection
rear display works normally.
AC309223
AC
CONNECTOR: F-34
HARNESS SIDE
AC309223
AD
CONNECTOR: F-35
HARNESS SIDE
21
22
23
24
25
26
VIDEO ENTERTAINMENT SYSTEM (VES)
TSB Revision
CHASSIS ELECTRICAL
54A-212
STEP 21. Check the wiring harness between DVD player
connector D-33 (terminal 13) and video controller unit
connector F-35 (terminal 22).
NOTE: Also check intermediate connector D-139 for loose, cor-
roded, or damaged terminals, or terminals pushed back in the
connector. If intermediate connector D-139 is damaged, repair
or replace. Refer to GROUP 00E, Harness Connector Inspec-
tion
.
Q: Is the wiring harness between DVD player connector
D-33 (terminal 13) and video controller unit connector
F-35 (terminal 22) in good condition?
YES : Go to Step 22.
NO : Repair the wiring harness. The rear display works
normally.
AC309208
HARNESS SIDE
D-33
D-139
AF
CONNECTORS: D-33, D-139
D-139
D-33
14
7
1
8
11
12
13
9
10
4
6 5
3 2
AC309223
AD
CONNECTOR: F-35
HARNESS SIDE
21
22
23
24
25
26
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст