Mitsubishi Montero (2004+). Manual — part 572
RV METER
TSB Revision
CHASSIS ELECTRICAL
54A-257
STEP 10. Recheck for malfunction.
Q: Is a malfunction eliminated?
YES : If no malfunctions are not found in all steps, an
intermittent malfunction is suspected. Refer to
GROUP 00,How to Use Troubleshooting/Inspection
Service Points
− How to Cope with Intermittent
Malfunction
NO : Replace the RV meter.
INSPECTION PROCEDURE 2: The Low Battery Warning Screen is Displayed.
AC204943
RV Meter Power Supply Circuit
RV METER
TSB Revision
CHASSIS ELECTRICAL
54A-258
.
CIRCUIT OPERATION
The RV meter is energized by the battery.
.
TECHNICAL DESCRIPTION (COMMENT)
the battery circuit is suspected to be open or defec-
tive.
.
TROUBLESHOOTING HINTS
• Malfunction of the battery
• Damaged harness wires and connectors
.
DIAGNOSIS
Required Special Tool:
• MB991223: Harness Set
STEP 1.Check the RV meter power supply.
Q: Is the abnormal voltage screen displayed immediately
after the ignition switch is turned to the ACC position?
YES : Go to Step 2.
NO : There is no action to be taken.
STEP 2.Check the RV meter battery power supply circuit
by backprobing.
(1) Do not disconnect RV meter connector D-07.
(2) Measure the voltage between terminal 26 and ground by
backprobing.
Q: Is the voltage approximately 12 volts (battery positive
voltage)?
YES : There is no action to be taken.
NO : Go to Step 3.
AC204170
CONNECTORS : D-02, D-07, D-28
DA
D-02
D-07(B)
D-28
AC204170
CONNECTOR : D-07
CT
HARNESS SIDE
D-07(B)
D-07(B)
22
23
30
31
25
26
33
34
32
24
28
3635
27
29
21
AC204738
28
26
34
27
35
25
33
23 24
32
36
22
30
21
29
31
AC204738 DU
HARNESS SIDE: D-07
RV METER
TSB Revision
CHASSIS ELECTRICAL
54A-259
STEP 3.Check RV meter connector D-07 for loose,
corroded or damaged terminals, or terminals pushed back
in the connector.
Q: Are RV meter connector D-07 in good condition?
YES : Go to Step 4.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
. The RV meter display
should operate normally.
STEP 4. Check the harness wires between RV meter
connector D-07 (terminal 26) and fusible link (1).
NOTE: Also check joint connector D-02 and intermediate con-
nector D-28, check the wires. If joint connector D-02 and inter-
mediate connector D-28 damaged, repair or replace them.
Refer to GROUP 00E, Harness Connector Inspection
Q: Are the harness wires between RV meter connector
D-07 (terminal 26) and fusible link (1) in good condition?
YES : Check the battery. (Refer to
.) If the battery
condition is normal, go to Step 5.
NO : Repair them. The RV meter should operate normally.
AC204170
CONNECTOR : D-07
CT
HARNESS SIDE
D-07(B)
D-07(B)
22
23
30
31
25
26
33
34
32
24
28
3635
27
29
21
AC204188
CONNECTORS: D-02, D-07, D-28
BR
D-28
D-28
D-02
2 3
27
32
28
33
16
15
4 5
19
18
29
17
34
7 8
35
22
21
9 10
30
36
31
37
25
24
23
6
20
1
14
26
11
13
12
38
HARNESS SIDE
D-07(B)
D-07(B)
22
23
30
31
25
26
33
34
32
24
28
3635
27
29
21
9 10
8
6 7
31 32
30
29
18 19 20 21
5
4
2
1
3
27
26
24
23
25
12 13 14 15 16 17
28
11
22
33
HARNESS SIDE
D-02
RV METER
TSB Revision
CHASSIS ELECTRICAL
54A-260
STEP 5. Recheck for malfunction.
Q: Is a malfunction eliminated?
YES : If no malfunctions are not found in all steps, an
intermittent malfunction is suspected. Refer to
GROUP 00,How to Use Troubleshooting/Inspection
Service Points
− How to Cope with Intermittent
Malfunction
NO : Replace the RV meter.
INSPECTION PROCEDURE 3: The Abnormal Drive Range is Displayed.
POWERTRAIN
CONTROL
MODULE
JOINT
CONNECTOR (5)
RV METER
FUEL LEVEL
SENSOR
Range Distance Display Circuit
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст