Mitsubishi Montero (2004+). Manual — part 499
TIRE PRESSURE MONITORING SYSTEM (TPMS) DIAGNOSIS
TSB Revision
WHEEL AND TIRE
31-67
STEP 6. Measure the resistance at C-118 TPMS receiver
connector.
(1) Disconnect TPMS receiver connector G-28, and check at
the harness side.
(2) Measure the resistance between terminal 6 and ground. It
should measure less than 2 ohms.
Q: Is the measured resistance less than 2 ohms?
YES : Go to Step 9.
NO : Go to Step 7.
STEP 7. Check the following connector.
• TPMS receiver connector G-28
Check the connector for loose, corroded or damaged terminals,
or terminals pushed back in the connector.
Q: Are the connector and terminals in good condition?
YES : Go to Step 8.
NO : Repair it. And then go to Step 12.
AC307592 AE
CONNECTOR : G-28
AC308264
AC307575
G-28
CONNECTOR: G-28
AI
G-28
10
5
6
7
9 8
3
4
2 1
HARNESS CONNECTOR:
COMPONENT SIDE
AC307592 AE
CONNECTOR : G-28
TIRE PRESSURE MONITORING SYSTEM (TPMS) DIAGNOSIS
TSB Revision
WHEEL AND TIRE
31-68
STEP 8. Check the following harness wire.
• The wire between TPMS receiver connector G-28 (terminal
6) and ground.
Q: Is the harness wire damaged?
YES : Repair or replace it. And then go to Step 12.
NO : Return to Step 6.
AC307592
G-28
AF
G-28
10
5
6
7
9 8
3
4
2 1
HARNESS CONNECTOR:
COMPONENT SIDE
CONNECTOR: G-28
TIRE PRESSURE MONITORING SYSTEM (TPMS) DIAGNOSIS
TSB Revision
WHEEL AND TIRE
31-69
STEP 9. Check the TPMS warning light circuit at TPMS
receiver connector G-28.
(1) Disconnect TPMS receiver connector G-28.
(2) Turn the ignition switch to the "ON" position.
(3) Ground terminal 7 of disconnected connector G-28 from the
TPMS receiver. The TPMS warning light should illuminate.
Q: Does the TPMS warning light illuminate?
YES : Replace the TPMS receiver (Refer to
execute "Tire Pressure Sensor ID Registration" on
scan tool MB991958 "Special Function" (Refer to
). And then go to Step 12.
NO : Go to Step 10.
AC307592 AE
CONNECTOR : G-28
AC308264
AC307575
G-28
CONNECTOR: G-28
AJ
G-28
10
5
6
7
9 8
3
4
2 1
HARNESS CONNECTOR:
COMPONENT SIDE
AC205999
H
C
AT
TEMP
SRS
P
R
N
D
5
4
3
2
1
x1000r/min
2
3
4
5
6
7
8
1
0
AC307585
TIRE PRESSURE MONITORING SYSTEM (TPMS) DIAGNOSIS
TSB Revision
WHEEL AND TIRE
31-70
STEP 10. Check the following connectors.
• Combination meter connector D-04
• Intermediate connector D-112
• TPMS receiver connector G-28
Check the connectors for loose, corroded or damaged termi-
nals, or terminals pushed back in the connector.
Q: Are the connectors and terminals in good condition?
YES : Go to Step 11.
NO : Repair it. And then go to Step 12.
AC204170
CONNECTOR: D-04
EL
D-04
COMBINATION METER
CONNECTOR
D-04 (GR)
AC204171 AL
CONNECTOR : D-112
2 3
27
32
28
33
16
15
4 5
19
18
29
17
34
7 8
35
22
21
9 10
30
36
31
37
25
24
23
6
20
1
14
26
11
13
12
38
AC307592 AE
CONNECTOR : G-28
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст