Mitsubishi Montero (2004+). Manual — part 483
GENERAL DESCRIPTION
TSB Revision
WHEEL AND TIRE
31-3
CIRCUIT DIAGRAM
• The TPMS receiver processes input signals from
each TPMS transmitter as well as vehicle speed
signals from the vehicle speed sensor. When the
road tire pressure is low, it sends a warning sig-
nal causing the TPMS warning light to be illumi-
nated. When the TPMS has problems, it sends a
warning signal causing the TPMS warning light to
be flashed.
• The TPMS transmitter includes a roll switch that
senses tire rotation. The TPMS receiver can
determine which tires are rotating (road tire) and
stationary (spare tire).
• For 3 seconds after the ignition switch is turned to
the "ON" position, the TPMS receiver illuminates
the TPMS warning light to check any breaks in
the TPMS warning light circuit.
AC307586
RELAY
BOX
JUNCTION
BLOCK
COMBINATION
METER
TPMS
RECEIVER
DATA LINK
CONNECTOR
FRONT TIRE (LH)
FRONT TIRE (RH)
REAR TIRE (LH)
REAR TIRE (RH)
IGNITION SWITCH (IG1)
FUSIBLE LINK
TPMS
POWER
SUPPLY
GND
RECEIVING CIRCUIT
EEPROM
VEHICLE
SPEED
SENSOR
CPU
TPMS TRANSMITTER
TPMS ANTENNA
(FRONT: LH)
CONTROL CIRCUIT
TPMS ANTENNA
(FRONT: RH)
CONTROL CIRCUIT
TPMS ANTENNA
(REAR: LH)
CONTROL CIRCUIT
CPU
TRANSMISSION
CIRCUIT
SPARE TIRE
18
15A
6
10A
10
20A
2
FUSIBLE LINK
1
AB
ANTENNA
TPMS ANTENNA
(REAR: RH)
CONTROL CIRCUIT
PRESSURE
SENSOR
ROLL
SWITCH
BATTERY
GENERAL DESCRIPTION
TSB Revision
WHEEL AND TIRE
31-4
• By connecting the scan tool to the data link con-
nector, data stored in the TPMS receiver (data of
tire pressure and tire pressure sensor ID, the
alarm status and warning history, etc.) can be dis-
played and the tire pressure sensor ID can be
registered.
TPMS WARNING LIGHT
The TPMS warning light on the combination meter illuminates
or flashes to alert the driver when signals are entered from the
TPMS receiver.
NOTE:
.
•
Immediately after the tire pressure sensor ID has been rec-
ognized, the TPMS receiver cannot recognize the road tires
until the vehicle is driven for some time. Therefore, if the
spare tire pressure is low, the TPMS warning light will illumi-
nate.
•
The tire pressure monitoring is not applicable for the spare
tire. Therefore, if the low-pressure road tire is used as a
spare tire, the TPMS warning light will go out as soon as the
TPMS receiver recognizes that.
CIRCUMSTANCE
WARNING LIGHT
For 3 seconds after the ignition switch
is turned to the "ON" position
(warning light circuit self-check)
Illuminates
TPMS problems
Flashes
Low tire pressure of any road tire
Illuminates
AC205999
H
C
AT
TEMP
SRS
P
R
N
D
5
4
3
2
1
x1000r/min
2
3
4
5
6
7
8
1
0
AC307585
GENERAL DESCRIPTION
TSB Revision
WHEEL AND TIRE
31-5
TPMS TRANSMITTER (TIRE PRESSURE SENSOR)
The TPMS transmitter combines the valve and tire
pressure sensor in a single unit. The TPMS transmit-
ters are mounted inside the tires (including the spare
tire). The TPMS transmitter measures tire pressure
directly with its tire pressure sensor and sends radio
frequency signals to the antenna inside the wheel
house. The TPMS transmitter includes a roll switch
that senses tire rotation. The TPMS receiver can
determine which tires are rotating (road tire) and sta-
tionary (spare tire).
NOTE: Use only genuine wheels. The use of
non-genuine wheels may cause the improper instal-
lation of the TPMS transmitters, possibly resulting in
air leakage and damage to the TPMS transmitter.
.
TIRE PRESSURE SAMPLING TIMING
Tire pressure sampling: Once every 30 sec-
onds
.
DATA TRANSMISSION TIMING
If a sampled pressure varies by
±10 kPa
(1.5psi) from the last transmitted pressure
value, an additional transmission will occur.
NOTE: Vehicle moving = vehicle speed: approxi-
mately 30 km/h (19 mph) or more <roll switch: ON>
NOTE: Service period = First 15 minutes after vehi-
cle stops <roll switch: OFF>
NOTE: Vehicle stationary = Situations except vehicle
moving and service period <roll switch: OFF>
AC307594
AC307583
AC307584
AB
VALVE
TPMS TRANSMITTER
(TIRE PRESSURE SENSOR)
A
SECTION A - A
A
TPMS
ANTENNA
TPMS
TRANSMITTER
VEHICLE STATUS
TRANSMISSION
TIMING
At vehicle moving and
service period
once every 1 minute
At vehicle stationary
once every 1 hour
GENERAL DESCRIPTION
TSB Revision
WHEEL AND TIRE
31-6
TPMS ANTENNAS
The TPMS for Montero has four TPMS antennas. Each TPMS
antenna is installed inside the wheel house. The TPMS
antenna receives radio frequency signal from the TPMS trans-
mitter and sends it to the TPMS receiver via feeder cable.
TPMS RECEIVER
1. The TPMS receiver is installed at the inner quarter panel
(RH), and monitors the tire pressure of road tires except
spare tire. The TPMS receiver receives a signal from a
TPMS transmitter every one minute if the TPMS transmitter
is revolving (i.e. it is embedded in road wheel tire).
NOTE: The TPMS receiver detects automatically that the
tire is "spare" tire (not on the road). Then the receiver
ignores the spare tire. The spare tire transmitter sends a
signal once every hour if it stationary (i.e. it is embedded in
spare tire).
2. When the ignition switch is at the "LOCK" (OFF) position,
The TPMS receiver should operate intermittently (supplies
power to receiving circuit intermittently).
3. The TPMS receiver has the following functions:
• SCAN TOOL (MUT-III) communication functions
• Warning function
.
SCAN TOOL (MUT-III) COMMUNICATION
FUNCTIONS
The following functions can be performed by con-
necting the scan tool to the data link connector and
starting the MUT-III.
• Diagnostic trouble code reading function
(for DTC chart, refer to
• Service data reading function
(for service data list, refer to
• Actuator testing function
(for test item, refer to
• Tire pressure sensor ID registration function
<TPMS special function (for data list, refer to
).>
NOTE: If the TPMS transmitters or TPMS
receiver are replaced, the tire pressure sensor ID
for all tires must be registered in the TPMS
receiver.
• Tire pressure sensor check function <TPMS spe-
cial function (for data list, refer to
).>
The pressure sensor data can be displayed by
using a magnet to send the signal from each
TPMS transmitter.
• Tire pressure sensor ID check function <TPMS
special function (for data list, refer to
).>
Each tire pressure sensor ID currently registered
in the TPMS receiver is displayed.
.
WARNING FUNCTIONS
The TPMS receiver determines the need for a warn-
ing based on the input data from the TPMS antennas
and the vehicle speed sensor signal from the vehicle
speed sensor. When the TPMS receiver sends a
warning signal (a TPMS warning light bulb check sig-
nal, a tire pressure warning signal, or a TPMS warn-
ing signal), the TPMS warning light on the
combination meter is illuminated or flashed. Three
seconds after the ignition switch is turned to the "ON"
position, or if the problem is corrected, the TPMS
warning light goes off.
AC307347AB
TPMS ANTENNAS
AC307592 AB
TPMS
RECEIVER
THIRD SEAT
BELT (RH)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст