Mitsubishi Montero (2004+). Manual — part 193
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
TSB Revision
MULTIPORT FUEL INJECTION (MFI)
13A-259
DIAGNOSIS
Required Special Tool:
• MB991316: Test Harness
STEP 1. Check harness connector C-14 at the right bank
heated oxygen sensor (rear) for damage.
Q: Is the harness connector in good condition?
YES : Go to Step 2.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
. Then go to Step 12.
AK201276
1
2
3
4
CONNECTOR: C-14
C-14(GR)
AB
HARNESS
CONNECTOR:
COMPONENT SIDE
RIGHT BANK
HEATED OXYGEN
SENSOR (REAR)
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
TSB Revision
MULTIPORT FUEL INJECTION (MFI)
13A-260
STEP 2. Check the right bank heated oxygen sensor (rear).
(1) Disconnect right bank heated oxygen sensor (rear)
connector C-14 and connect test harness special tool,
MB991316, to the connector on the right bank heated
oxygen (rear) sensor side.
(2) Measure the resistance between heated oxygen sensor
connector terminal No. 1 (red clip) and terminal No. 3 (blue
clip).
Standard value: 11
− 18 ohms [at 20°C (68°F)]
Q: Is the measured resistance between 11 and 18 ohms [at
20
°C (68°F)]?
YES : Go to Step 3.
NO : Replace the right bank heated oxygen sensor (rear).
Then go to Step 12.
AK201276
1
2
3
4
CONNECTOR: C-14
C-14(GR)
AB
HARNESS
CONNECTOR:
COMPONENT SIDE
RIGHT BANK
HEATED OXYGEN
SENSOR (REAR)
AKX01624 AB
MB991316
HEATED
OXYGEN
SENSOR
EQUIPMENT
SIDE
CONNECTOR
BLUE
RED
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
TSB Revision
MULTIPORT FUEL INJECTION (MFI)
13A-261
STEP 3. Measure the power supply voltage at right bank
heated oxygen sensor (rear) harness side connector C-14.
(1) Disconnect the connector C-14 and measure at the harness
side.
(2) Turn the ignition switch to the "ON" position.
(3) Measure the voltage between terminal No. 1 and ground.
• Voltage should be battery positive voltage.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is battery positive voltage (approximately 12 volts)
present?
YES : Go to Step 5.
NO : Go to Step 4.
STEP 4. Check harness connector B-22X at the MFI relay
for damage.
Q: Is the harness connector in good condition?
YES : Check harness connectors E-114 and D-116 at
intermediate connector for damage, and repair or
replace as required. Refer to GROUP 00E, Harness
Connector Inspection
. If intermediate
connectors E-114 and D-116 are in good condition,
repair harness wire between MFI relay connector
B-22X (terminal No. 1) and right bank heated oxygen
sensor (rear) connector C-14 (terminal No. 1)
because of open circuit or short circuit to ground.
Then go to Step 12.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
. Then go to Step 12.
AK201276
1
2
3
4
CONNECTOR: C-14
C-14(GR)
AB
HARNESS
CONNECTOR:
COMPONENT SIDE
RIGHT BANK
HEATED OXYGEN
SENSOR (REAR)
AKX01496
C-14 HARNESS
CONNECTOR:
COMPONENT SIDE
1
2
3
4
AQ
AK200951
2 1
3
4
B-22X
AB
CONNECTOR: B-22X
HARNESS
CONNECTOR:
COMPONENT SIDE
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
TSB Revision
MULTIPORT FUEL INJECTION (MFI)
13A-262
STEP 5. Measure the power supply voltage at PCM
connector D-132 by backprobing.
(1) Do not disconnect the connector D-132.
(2) Turn the ignition switch to the "ON" position.
(3) Measure the voltage between terminal No. 24 and ground
by backprobing.
• Voltage should be battery positive voltage.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is battery positive voltage (approximately 12 volts)
present?
YES : Go to Step 8.
NO : Go to Step 6.
STEP 6. Check harness connector D-132 at PCM for
damage.
Q: Is the harness connector in good condition?
YES : Go to Step 7.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
. Then go to Step 12.
AK200938
2
3
4
5
6
7
8
9
1
10
14
15
16
17
18
19
20
21
22
23
24
25
26
27
11
12
13
AB
CONNECTOR: D-132
HARNESS CONNECTOR:
COMPONENT SIDE
PCM
D-132(GR)
AK201409
1
2
3
5
6 7 8 9
4
20
21 22
232425
2627
10111213
14 15
16 1718
19
D-132 HARNESS
CONNECTOR:
HARNESS SIDE
AB
AK200938
2
3
4
5
6
7
8
9
1
10
14
15
16
17
18
19
20
21
22
23
24
25
26
27
11
12
13
AB
CONNECTOR: D-132
HARNESS CONNECTOR:
COMPONENT SIDE
PCM
D-132(GR)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст