Mitsubishi Outlander GS45X. Manual — part 108

REAR VIEW CAMERA

TSB Revision

CHASSIS ELECTRICAL

54A-429

SYMPTOM PROCEDURES

Rear view camera image is not correctly displayed.

CAUTION

Before replacing the multivision display, ensure
that the power supply circuit, the ground circuit,
and the communication circuit are normal.
(Check that the voltage is 10 V or more.)

REAR VIEW CAMERA

TSB Revision

CHASSIS ELECTRICAL

54A-430

Rear View Camera Circuit

MULTIVISION DISPLAY

REAR VIEW CAMERA

ETACS-
ECU

TRANSMISSION
RANGE SWITCH

ETACS-
ECU

FUSIBLE
LINK

34

IGNITION
SWITCH (IG1)

IG1
RELAY

REAR VIEW CAMERA

TSB Revision

CHASSIS ELECTRICAL

54A-431

.

COMMENTS ON TROUBLE SYMPTOM

When the screen of rear view camera is not shown even if the
selector lever is "R" (Reverse) position, the rear view camera,
the wiring harness, connectors, transmission range switch or
multivision display may be defective.

.

PROBABLE CAUSES

• Damaged harness wires and connectors

• Malfunction of the transmission range switch

AC901112

Connector: A-13

AH

AC901625

AB

Connector: B-110 <2.4L ENGINE>

B-110 (B)

AC901598

AC

B-110 (B)

Connector: B-110 <3.0L ENGINE>

AC709494

AQ

Connectors: C-09, C-19, C-22

C-09 (GR)

C-22

C-19

ACA02653AD

Connectors: C-32, C-129

C-129

C-32

ACA02655AD

Connectors: C-309, C-315, C-317

C-315

C-317

C-309 (B)

AC803007

AB

Connector: D-38

AC803008

AB

Connector: F-21

REAR VIEW CAMERA

TSB Revision

CHASSIS ELECTRICAL

54A-432

• Malfunction of the rear view camera

• Malfunction of the multivision display

DIAGNOSIS

Required Special Tools:

• MB991223: Harness Set

• MB992006: Extra Fine Probe

• MB991958: Scan Tool (M.U.T.-III Sub Assembly)

• MB991824: Vehicle Communication Interface (V.C.I.)

• MB991827: M.U.T.-III USB Cable

• MB991910: M.U.T.-III Main Harness A

STEP 1. Using scan tool MB991958, read the ETACS-ECU
diagnostic trouble code.
(1) Operate scan tool MB991958 to read the ETACS-ECU

option coding information. (Refer to GROUP 00, Coding List

P.00-44

.)

(2) Check if the diagnostic trouble code is set to the

ETACS-ECU.

Q: Is the DTC set?

YES : Troubleshoot the ETACS-ECU (Refer to GROUP

54A, ETACS, Diagnosis

P.54A-732

), and then go to

Step 2.

NO : Go to Step 2.

STEP 2. Using scan tool MB991958, check data list.
Check if ETACS-ECU related signal is set.

• Turn the ignition switch to the ON position.

OK: Normal condition is displayed.

Q: Is the check result normal?

YES : Go to Step 3.
NO : Refer to Troubleshooting

− Inspection Procedure 1

"The ignition switch (IG1) signal is not received"

P.54A-788

.

ZC501967

AC404789

AC702802

MB991824

MB991827

MB991910

Data link

connector

AB

Item No.

Item name

Normal
conditions

254

IG voltage

System
positive voltage