Mitsubishi Outlander GS45X. Manual — part 1382
GENERAL INFORMATION
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-23
INTERFACE
CIRCUIT
HALL IC
AC803005
CENTER
PANEL
UNIT
ETACS-ECU
(FUSE )
12
SRS-ECU
AIR BAG OFF
INDICATOR
LIGHT
PASSENGER'S
SIDE
PASSENGER'S
SIDE
SEAT BELT
BUCKLE SWITCH
AD
GENERAL INFORMATION
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-24
COMPONENT LOCATION
NOTE: The illustration above shows the front impact
sensor (RH) and the side impact sensor (RH). The
position of the front impact sensor (LH) and the side
impact sensor (LH) is symmetrical to this.
AC506366
AC506815
ZC601277
ZC501967
AC901054 AB
Occupant classification-ECU
Seat slide sensor
Weight
sensor
SRS-ECU
Data link
connector
Side impact sensor (Rear)
Second
seat belt
Side impact sensor (Front)
Center pillar
Front impact sensor
Front end
upper bar
Curtain air bag module
Driver's air bag module
Clock spring
Passenger's (front)
air bag module
SERVICE PRECAUTIONS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-25
SERVICE PRECAUTIONS
M1524000301544
DANGER
•
In order to avoid injury to yourself or others from
accidental deployment of the air bag during servic-
ing, read and carefully follow all the precautions
and procedures described in this manual.
•
After disconnecting the battery cable, wait 60 sec-
onds or more before proceeding with the following
work. The SRS system is designed to retain
enough voltage to deploy the air bag for a short
time even after the battery has been disconnected,
so serious injury may result from unintended air
bag deployment if work is done on the SRS system
immediately after the battery cables are discon-
nected.
•
The SRS-ECU adopts the rollover specification
that the curtain airbag and seat belt pre-tensioner
operate at the occurrence of rollover. Therefore, do
not tilt the vehicle to the right and left with the IG
ON or tilt the SRS-ECU to the right and left with the
IG ON and the harness installed.
WARNING
•
Battery posts, terminals and related accessories
contain lead and lead compounds. WASH HANDS
AFTER HANDLING.
•
Certain components of this vehicle, such as air
bag modules and seat belt pre-tensioners, may
contain perchlorate materials. Special handling
may apply. For additional information, see
www.dtsc.ca.gov/hazardouswaste/perchlorate.
•
Do not use any electrical test equipment on or near
the SRS components, except those specified on
•
Never Attempt to Repair the Following Compo-
nents: SRS-ECU, Clock Spring, Air Bag Module,
Front impact sensor, Side Impact Sensor, Seat Belt
with Pre-tensioner, Seat slide sensor, Front seat
assembly. If any of these components are diag-
nosed as faulty, they should only be replaced, in
accordance with the INDIVIDUAL COMPONENT
SERVICE procedures in this manual, starting on
AC300580AB
Insulating tape
Battery
Battery cable
SERVICE PRECAUTIONS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-26
•
Do not attempt to repair the wiring harness con-
nectors of the SRS. If any of the connectors are
diagnosed as faulty, replace the wiring harness. If
the wires are diagnosed as faulty, replace or repair
the wiring harness according to the following
table.
.
AC506921AB
SRS-ECU connector
SRS-ECU terminal No.
Destination of wiring harness
Corrective action
5, 6
Instrument panel wiring harness
→
Clock spring
→ Air bag module
(Driver's side) 1st squib side
Correct or replace the instrument panel
wiring harness. Replace the clock
spring.
7, 8
Instrument panel wiring harness
→ Air
bag module (Front passenger's side)
1st squib side
Correct or replace the instrument panel
wiring harness.
9, 10
Instrument panel wiring harness
→
Clock spring
→ Air bag module
(Driver's side) 2nd squib side
Correct or replace the instrument panel
wiring harness. Replace the clock
spring.
11, 12
Instrument panel wiring harness
→ Air
bag module (Front passenger's side)
2nd squib side
Correct or replace the instrument panel
wiring harness.
15, 16
Can line
Correct or replace can line.
17
Instrument panel wiring harness
→
Ground
Correct or replace the instrument panel
wiring harness.
18
Instrument panel wiring harness
→ Air
bag OFF indicator light
Correct or replace the instrument panel
wiring harness.
21, 22
Instrument panel wiring harness
→
Front wiring harness
→ Front impact
sensor (LH)
Correct or replace each wiring harness.
23, 24
Instrument panel wiring harness
→
Front wiring harness
→ Front impact
sensor (RH)
Correct or replace each wiring harness.
31, 32
Floor wiring harness
→ Side-airbag
module (LH)
Correct or replace the floor wiring
harness.
33, 34
Floor wiring harness
→ Side-airbag
module (RH)
Correct or replace the floor wiring
harness.
35, 36
Floor wiring harness
→ Lap
pre-tensioner
Correct or replace the floor wiring
harness.
39, 40
Floor wiring harness
→ Curtain air bag
wiring harness (RH)
→ Curtain air bag
module (RH)
Correct or replace each wiring harness.
41, 42
Floor wiring harness
→ Curtain air bag
wiring harness (LH)
→ Curtain air bag
module (LH)
Correct or replace each wiring harness.
43, 44
Floor wiring harness
→ Seat belt
pre-tensioner (RH)
Correct or replace the floor wiring
harness.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст