Mitsubishi Outlander GS45X. Manual — part 74
DOME LIGHT
TSB Revision
CHASSIS ELECTRICAL
54A-293
STEP 2. Using scan tool MB991958, check data list.
Use the ETACS-ECU service data to check the signals related
to the operation of luggage compartment light.
• Turn the ignition switch to the "LOCK" (OFF) position.
• Remove the ignition key from the ignition key cylinder.
• Open each door.
• Open the liftgate.
Q: Does scan tool MB991958 display the items "Dr door
unlock", "IG voltage", "Dr door ajar switch", "As door
ajar switch", "RR door ajar switch", "RL door ajar
switch", "Trunk/gate trunk ajar switch" and "Handle
lock switch" as normal condition?
YES <Normal conditions are displayed for all items.> :
Go to step 3.
NO <Normal condition is not displayed for item No.
228.> : Troubleshoot the ETACS-ECU. Refer to Inspection
Procedure 4 "ETACS-ECU does not receive any
signal from the front door lock actuator"
NO <Normal condition is not displayed for item No.
254.> : Troubleshoot the ETACS-ECU. Refer to Inspection
Procedure 2 "ETACS-ECU does not receive any
signal from the ignition switch (IG1)"
.
NO <Normal condition is not displayed for item No.
256.> : Troubleshoot the ETACS-ECU. Refer to Inspection
Procedure 5 "ETACS-ECU does not receive any
signal from the front door switch (LH)"
NO <Normal condition is not displayed for item No.
257.> : Troubleshoot the ETACS-ECU. Refer to Inspection
Procedure 6 "ETACS-ECU does not receive any
signal from the front door switch (RH)"
NO <Normal condition is not displayed for item No.
258.> : Troubleshoot the ETACS-ECU. Refer to Inspection
Procedure 7 "ETACS-ECU does not receive any
signal from the rear door switch (LH)"
.
NO <Normal condition is not displayed for item No.
259.> : Troubleshoot the ETACS-ECU. Refer to Inspection
Item No.
Item name
Normal
conditions
Item 228
Dr door unlock
ON
Item 254
IG voltage
1 V or less
Item 256
Dr door ajar switch
Open
Item 257
As door ajar switch
Open
Item 258
RR door ajar switch Open
Item 259
RL door ajar switch
Open
Item 260
Trunk/gate trunk ajar
switch
Open
Item 264
Handle lock switch
Key in
→ Key
out
DOME LIGHT
TSB Revision
CHASSIS ELECTRICAL
54A-294
Procedure 8 "ETACS-ECU does not receive any
signal from the rear door switch (RH)"
NO <Normal condition is not displayed for item No.
260.> : Troubleshoot the ETACS-ECU. Refer to Inspection
Procedure 9 "ETACS-ECU does not receive any
signal from the liftgate switch"
.
NO <Normal condition is not displayed for item No.
264.> : Troubleshoot the ETACS-ECU. Refer to Inspection
Procedure 3 "ETACS-ECU does not receive any
signal from the key reminder switch"
STEP 3. Check luggage compartment light connector F-02
for loose, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Is luggage compartment light connector F-02 in good
condition?
YES : Go to Step 4.
NO : Repair the damaged parts.
STEP 4. Luggage compartment light bulb check
Check that the luggage compartment light bulb is normal.
Q: Does luggage compartment light work normally?
YES : Go to Step 5.
NO : Replace the luggage compartment light bulb.
STEP 5. Check ETACS-ECU connector C-311 for loose,
corroded or damaged terminals, or terminals pushed back
in the connector.
Q: Is ETACS-ECU connectors C-311 in good condition?
YES : Go to Step 6.
NO : Repair the damaged parts.
STEP 6. Check the wiring harness between luggage
compartment light connector F-02 (terminal No. 2/1) and
ETACS-ECU connector C-311 (terminal No. 3/17).
Check the communication line for open or short circuit.
NOTE: Prior to the wiring harness inspection, check intermedi-
ate connector D-12, and repair if necessary.
Q: Is wiring harness between luggage compartment light
connector F-02 (terminal No. 2/1) and ETACS-ECU
connector C-311 (terminal No. 3/17) in good condition?
YES : Go to Step 7.
NO : Repair the wiring harness.
DOME LIGHT
TSB Revision
CHASSIS ELECTRICAL
54A-295
STEP 7. Retest the system
Check that the luggage compartment light illuminates/extin-
guishes normally.
Q: Does the luggage compartment light work normally?
YES : The trouble can be an intermittent malfunction (Refer
to GROUP 00
− How to use
Troubleshooting/inspection Service Points
− How to
Cope with Intermittent Malfunction
NO : Replace the ETACS-ECU.
DOME LIGHT
TSB Revision
CHASSIS ELECTRICAL
54A-296
Inspection Procedure 4: The foot light does not illuminate normally.
Foot Light Circuit
FUSIBLE
LINK
34
RELAY BOX
FOOT
LIGHT (LH)
FOOT
LIGHT (RH)
LIMIT
SWITCH
FOOT
LIGHT
TIMER RELAY
LIMIT
SWITCH
FOOT
LIGHT
TIMER RELAY
PASSENGER
COMPARTMENT
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст