Mitsubishi Eclipse. Technical Information Manual (1994) — part 29
POWER TRAIN
Clutch
The clutch is a dry single-disc, diaphragm type;
hydraulic pressure is used for clutch control,
The automatic centering type release bearing has
been adopted.
SPECIFICATIONS
Items
Clutch operating method
Non-turbo
Hydraulic type
Turbo
Clutch disc type
Clutch disc facing diameter
Single dry disc type
O.D. x I.D.
Clutch cover type
Clutch cover setting load
Clutch release cylinder
I.D.
mm (in.)
N (Ibs.)
228 x 150 (9.0 x 5.9)
225 x 150 (8.9 x 5.9)
Diaphragm spring strap drive type
4,400 (989)
6,174 (1,388)
mm (in.)
22.23
20.64
POWER TRAIN Clutch
CLUTCH CONTROL
A hydraulic system has been adopted for the control
of the clutch. It offers the following features.
switch has been equipped (within the pedal
A clutch fluid chamber and a compression type
port bracket)
turnover spring have been adopted for better
l
<Turbo>
pedal feeling and less foot pressure.
The clutch switch for the auto-cruise control
l
In order to prevent sudden movement of the
system has been equipped at the pedal support
vehicle when the engine is started, an inter-lock
bracket.
Clutch hose
Clutch release
<Non-turbo>
Clutch release
Clutch pipe
Pedal
bracket
Clutch fluid chamber
master
POWER TRAIN Clutch
Inter-lock
INTER-LOCK SWITCH
The inter-lock switch is a switch provided in order to prevent
sudden movement of the vehicle when the engine is started.
Thus, the starter motor will not be switched ON unless the
clutch pedal is depressed, thereby switching OFF the inter-lock
switch.
NOTE
The inter-lock switch is normally ON; it is switched OFF when
the clutch pedal is depressed.
IGNITION SWITCH (ST)
I
STARTER
RELAY
INTER-LOCK
SWITCH
STARTER MOTOR
If the Clutch Pedal is Not Depressed:
Because the inter-lock switch is switched ON when
the ignition switch is switched to the START position,
electricity flows from the coil of the starter relay,
through the inter-lock switch, to ground. As a result,
the contacts of the starter relay separate, switching
it OFF, and the starter motor is therefore not acti-
vated.
When the Clutch Pedal is Depressed:
The inter-lock switch is switched OFF when the
clutch pedal is depressed. If the ignition switch is
then switched to the START position at this time,
the flow of electricity to the coil of the starter relay
will be interrupted, the contacts of the starter relay
will close, switching it ON, and the starter motor
will be activated.
POWER TRAIN Manual Transaxle
Three types of manual transaxle,
and
have been provided.
is a newly developed small and light-weight
transaxle produced by Chrysler Corporation, while
and
transaxles are essentially the
same as the conventional ones.
SPECIFICATIONS
Drive type
Transmission model
Engine model
Transmission type
Gear ratio (number of teeth)
1st
2nd
3rd
4th
5th
Reverse
Reduction ratio (number of teeth)
Primary
Secondary
Transfer
Reverse brake
Speedometer gear ratio
FWD
AWD
Non-turbo
Turbo
Turbo
constant mesh
constant mesh
constant mesh
3.538
3)
3.090
1)
3.083
2)
2.125
1.833
8)
1.684
9)
1.360
1.217
1.115
1.029
0.888
0.833
0.810
0.741
0.666
3.417
3.166
2)
3.166
2)
3.944
8)
1.208
1.275
3.437
6)
3.866
5)
1.090
Provided
Provided
Provided
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст