Mitsubishi Eclipse. Technical Information Manual (1994) — part 34
POWER TRAIN
Manual Transaxle
OUTPUT SHAFT
The front of the output shaft is supported by a roller
The rear of the output shaft is supported by a sealed
bearing that rides in the front transaxle case housing.
ball bearing in the rear case.
Output shaft
Rear sealed
ball bearing
Front
roller
bearing
l-2 sleeve
1 st speed
gear
Pinion gear
erse
. .
POWER TRAIN
Manual Transaxle
Output Shaft Assembly
The output shaft assembly transmits torque from
supported by the front case. The rear of the shaft
the input shaft to the differential ring gear. The front
is supported by a sealed ball bearing located in
of the output shaft rides in a caged roller bearing
the rear case.
gear teetn
shaft
2nd speed
gear
4th gear
POWER TRAIN
Manual Transaxle
The assembly consists of the output shaft, l-2
chronizer assembly, first and second speed gears,
snap rings and needle bearings. First and
speed gears use caged needle bearings that rotate
on the shaft journals. Third, fourth and fifth gears
are heated and pressed on the output shaft.
al components are not serviceable because of the
heat and press operations, if any of the components
fail the entire assembly must be replaced.
1. Output shaft
2. First gear bearing
9. Second gear bearing
10. Inner cone
3. First speed gear
11. Outer cone
4. First gear stop ring
5. Outer cone
12. Second gear storing
6. Inner cone
13. Second speed gear
7. l-2 synchronizer
14. Third and fourth gears
15. Fifth
8. l-2 synchronizer snap ring
gear
16. Fifth gear snap ring
POWER TRAIN
Manual Transaxle
REVERSE IDLER
The reverse idler gear shaft is supported by the
front and rear cases.
Rear case
support
Reverse
idler gear
Front case
4
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст