Mitsubishi Space Star. Manual — part 129
POWER PLANT MOUNT –
Transmission Mounting
32-3
TRANSMISSION MOUNTING
REMOVAL AND INSTALLATION
Caution
Mounting locations marked by * should be provisionally tightened, and then fully tightened when
the body is supporting the full weight of the engine.
Pre-removal and Post-installation Operation
Air Cleaner Assembly Removal and Installation
90 Nm*
54 Nm
3
1
2
50 Nm
Removal steps
Centermember mounting bolt
A
1. Transmission mount bracket
A
2. Transmission mount stopper
3. Transmission mount lower bracket
REMOVAL SERVICE POINT
A
TRANSMISSION MOUNT BRACKET REMOVAL
1.
Install the special tool to the vehicle body to support the
engine and transmission assembly.
2.
Remove the centermember mounting bolts.
3.
Remove the bolt and nuts of the transmission mount
bracket.
4.
After lowering the engine and transmission assembly,
remove the transmission mount bracket.
MB991453
MZ203827
POWER PLANT MOUNT –
Transmission Mounting
32-4
INSTALLATION SERVICE POINT
A
TRANSMISSION MOUNT STOPPER INSTALLATION
Install the transmission mount stopper so that the arrow mark
points toward the shown direction.
Engine side
Arrow
Transmission
mount stopper
Transmission
mount bracket
POWER PLANT MOUNT –
Engine Roll Stopper, Centermember
POWER PLANT MOUNT –
Engine Roll Stopper, Centermember
32-5
ENGINE ROLL STOPPER, CENTERMEMBER
REMOVAL AND INSTALLATION
Caution
Mounting locations marked by * should be provisionally tightened, and then fully tightened when
the body is supporting the full weight of the engine.
39 Nm
54 Nm*
54 Nm*
69 Nm
4
3
5
6
2
5
69 Nm
1
39 Nm
7
1
6
7
10 Nm
8
Removal steps
1. Bolt
B
2. Front roll stopper bracket assembly
3. Rear roll stopper heat protector
A
4. Rear roll stopper bracket assembly
5. Bushing (lower)
6. Bushing (upper)
7. Collar
8. Centermember
INSTALLATION SERVICE POINTS
A
REAR ROLL STOPPER BRACKET ASSEMBLY
INSTALLATION
Install so that the hole in the rear roll stopper bracket is facing
towards the rear of the vehicle.
Hole
Front of vehicle
POWER PLANT MOUNT –
Engine Roll Stopper, Centermember
32-6
B
FRONT ROLL STOPPER BRACKET ASSEMBLY
INSTALLATION
Install so that the hole in the front roll stopper bracket is facing
towards the front of the vehicle.
Hole
Front of vehicle
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст