Mitsubishi Lancer Evolution 8. Manual — part 152
4G6 ENGINE – CAMSHAFT, VALVE STEM SEAL
11A-10
L
FITTING CAMSHAFT END SEALS
Apply sealant to the locations on the camshaft end seal, as shown in the
diagram, then fit to the cylinder head.
Semi-dry sealant: Three Bond 1211
M
FITTING ROCKER COVER ASSY
1. Apply sealant to the 6 locations on the rocker cover gasket, as shown
in the diagram.
Semi-dry sealant: Three Bond 1207D
2. Fit the rocker cover ASSY to the cylinder head.
N
CONNECTING RADIATOR UPPER HOSE
1. Insert radiator upper hose as far as the protrusion on the water outlet
fitting.
2. Align the radiator upper hose and hose clamp matching marks to fit the
radiator upper hose.
Cylinder head
Engine forward direction
Protrusion
Water outlet
fitting
Matching mark
4G6 ENGINE – TIMING BELT, TIMING BELT B
11A-11
TIMING BELT and TIMING BELT B
Removal and Fitting
Caution
When Brembo brake callipers are used, there is concern over paint peeling off, so when doing servicing work, make
sure they are not scratched by other components and tools. Furthermore, if any brake fluid gets onto the calipers, it
should be wiped off immediately.
Jobs to do before removal and after fitting
• Removal and fitting of undercover (refer to Chapter 51 Front Bumper)
• Removal and fitting of LH side cover
• Checking drive belt tension <only after fitting>
• Removal and fitting of crank shaft pulley
• Removal and fitting cross member bar
• Removal and fitting of front exhaust pipe
Removal procedure
1. Timing belt front upper cover
2. Water pump pulley
3. Idler pulley
4. Drive belt auto-tensioner
5. Timing belt front lower cover
• Timing belt tension adjustment
6. Timing belt
7. Tensioner pulley
8. Connecting earth cable
9. Auto-tensioner
10. Idler pulley
G
A
F
E
D
4G6 ENGINE – TIMING BELT, TIMING BELT B
11A-12
11. Crank angle sensor
12. Crank shaft sprocket
13. Crank shaft sensing blade
• Timing belt B tension adjustment
14. Timing belt B tensioner
15. Timing belt B
B
C
C
B
A
C
A
Note
Carry out removal and fitting in accordance with existing
instructions
(Engine oil)
FUEL SUPPLY GENERAL INFORMATION
13B-1
SECTION 13B
CONTENTS
General Information
The following servicing information has been issued in conjunction with changes to the fuel tank.
General Information. . . . . . . . ...1
Fuel Tank . . . . . . . . . . . . ...2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст