Mitsubishi Lancer Evolution IX. Manual — part 281
HEADLAMP
CHASSIS ELECTRICAL
54A-61
POSITION LAMP BULB
CAUTION
Do not touch the bulb surface bare-handed or
with dirty gloves. If dirt is attached on surface of
the bulb, immediately use alcohol or thinner to
remove dirt, and install the bulb after well dried.
AC310336
Position lamp
AB
1. Remove the splash shield.
2. Screw out the position lamp socket to pull out the
position lamp bulb.
FRONT TURN-SIGNAL LAMP BULB
CAUTION
Do not touch the bulb surface bare-handed or
with dirty gloves. If dirt is attached on surface of
the bulb, immediately use alcohol or thinner to
remove dirt, and install the bulb after well dried.
AC310337
Front turn-signal lamp
AB
1. Remove the splash shield.
2. Screw out the front turn-signal lamp socket to pull
out the front turn-signal lamp bulb.
HEADLAMP
REMOVAL AND INSTALLATION
M1542001800299
Post-installation Operation
Headlamp Aiming Adjustment (Refer to
).
AC310338AB
2.5± 0.4 N·m
4.9 ± 0.9 N·m
1
2
4.9 ± 0.9 N·m
4.9 ± 0.9 N·m
Removal steps
1.
Air guide panel
2.
Headlamp assembly
HEADLAMP
CHASSIS ELECTRICAL
54A-62
HEADLAMP LEVELING SWITCH
REMOVAL AND INSTALLATION
M1542013700084
AC310339AB
2
1
Removal steps
1. Switch panel
2. Headlamp levelling switch
INSPECTION
M1542011201127
HEADLAMP LEVELING SWITCH RESIST-
ANCE CHECK
AC305186AB
Terminal No.
Switch
position
Resistance
4 - 6
0
750 ohms
1
1050 ohms
2
1410 ohms
3
1710 ohms
4
2010 ohms
5 - 6
0, 1, 2, 3, 4
2830 ohms
REAR FOG LAMP
CHASSIS ELECTRICAL
54A-63
REAR FOG LAMP
TROUBLESHOOTING
M1542000701623
If the rear fog lamp switch is turned ON when the
headlamp is turned ON, the rear fog lamp is switched
ON and OFF alternatively.
If the headlamp and the rear fog lamp is turned OFF
at the same time.
The rear fog lamp is controlled by the Smart Wiring
System (SWS). For Troubleshooting, refer to respec-
tive Groups below.
• Not using SWS monitor: GROUP 54B, SWS
Troubleshooting
.
• Using SWS monitor: GROUP 54C, SWS Trouble-
SPECIAL TOOL
M1542000601176
Tool
Number
Name
Use
MB990784
MB990784
Ornament remover Removal of switch panel
REAR FOG LAMP
REMOVAL AND INSTALLATION
M1542009800118
AC310340
2
4
3
1
AB
4.9 ± 0.9 N·m
Removal steps
1. Rear combination lamp assembly
2. Rear combination lamp body
3. Rear fog lamp socket
4. Bulb
Removal steps (Continued)
REAR FOG LAMP
CHASSIS ELECTRICAL
54A-64
REAR FOG LAMP SWITCH
REMOVAL AND INSTALATION
M1542014200026
AC310880AB
2
1
Removal steps
1. Switch panel
2. Rear fog lamp switch
INSPECTION
M1542011201138
REAR FOG LAMP SWITCH CONTINUITY
CHECK
AC305187AB
Switch position Tester
connection
Specified
condition
Pressed
5
− 6
Less than 2
ohms
Released
5
− 6
Open circuit
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст