Mitsubishi Lancer. Manual — part 201
PARKING BRAKE LINING AND DRUM
PARKING BRAKES
36-8
REMOVAL SERVICE POINTS
<<A>> REAR BRAKE ASSEMBLY
REMOVAL
Remove the rear brake assembly and support it with
wire or something similar.
<<B>> REAR BRAKE CHAMBER
RETAINER REMOVAL
AC000924AG
Rear brake secondary
shoe assembly pin
Rear brake chamber retainer
Use a flat-tipped screwdriver or a similar tool to open
up the rear brake chamber retainer joint. Then
remove the rear brake chamber retainer.
INSTALLATION SERVICE POINTS
>>A<< REAR BRAKE WASHER INSTAL-
LATION
AC304675 AB
Rear brake secondary
shoe assembly
Rear brake
chamber retainer Parking brake
operating lever
Rear brake
washer
Install the rear brake washer in the direction shown
in the illustration.
>>B<< REAR BRAKE CHAMBER
RETAINER INSTALLATION
AC000926AI
Rear brake secondary
shoe assembly pin
Rear brake chamber retainer
Use pliers or a similar tool to close the rear brake
chamber retainer end onto the pin.
>>C<< SHOE SLACK ADJUSTER
INSTALLATION
AC304676 AB
Shoe adjusting bolt
Shoe adjusting bolt
Left rear wheel
Right rear wheel
Rear of
the vehicle
Rear of
the vehicle
Install the shoe slack adjuster so that the shoe
adjusting bolt for the left rear wheel is attached
towards the front of the vehicle, and the shoe adjust-
ing bolt for the right rear wheel is towards the rear of
the vehicle.
PARKING BRAKE LINING AND DRUM
PARKING BRAKES
36-9
>>D<< SHOE RETURN SPRINGS
INSTALLATION
AC202302AC
Front of the vehicle
Blue paint
Yellow paint
The shoe return springs are not interchangeable as
their constants are different. The one with blue paint
mark should be install at the front of the vehicle, and
the other with yellow paint at the rear of the vehicle,
respectively.
NOTE: The illustration shows the left rear wheel. The
right rear wheel is symmetrical to that.
INSPECTION
M1361002600248
PARKING BRAKE LINING AND DRUM
CHECK
ACX00708AB
1. Measure the thickness of the brake lining at
several places.
Standard value: 2.8 mm
Limit: 1.0 mm
2. If the thickness of the brake lining is below the
limit, replace the shoe assemblies on both sides
of the vehicle. Never replace only one side.
ACX00709
3. Measure the inside diameter of the brake disc in
two places or more.
Standard value: 168.0 mm
Limit: 169.0 mm
4. If the inside diameter exceeds the limit, or if it is
excessively worn on one side, replace the rear
brake disc.
NOTES
13-1
GROUP 13
CONTENTS
MULTIPORT FUEL INJECTION (MPI) <4G1> . . . . . . . . . . . . . .
MULTIPORT FUEL INJECTION (MPI) <4G6> . . . . . . . . . . . . . .
FUEL SUPPLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст