Mitsubishi Lancer. Manual — part 36

: Nozzle insertion openings

Application surfaces

AB300703AC

13

AB300915AB

H

AB301049 AB

14

AB300700

AB

15

AB300916

AB

I

WAX INJECTION LOCATIONS

CORROSION PROTECTION

4-14

ROCKER PANEL PRIMER APPLICATION LOCATIONS

CORROSION PROTECTION

4-15

ROCKER PANEL PRIMER APPLICATION LOCATIONS

M4040002000142

To prevent rusting from chipping (flying rock), a prim-
ing panel primer has been applied to the areas indi-
cated in the figure.

The priming panel primer is applied between the
under and middle coat. It improves anti-corrosive
performance by preventing flying rock to damage the
body panel with the primer application, according to
the thickness and elasticity of the primer. Apply the
primer before the middle coat when replacing the
panel complete with a priming panel primer applica-
tion.

AB300549

AB300551

A

AB

<Sedan>

AB300550

AB300552

A

AB

<Wagon>

AB300582AB

: Rocker panel primer

A

35 mm

UNDERCOAT APPLICATION LOCATIONS

CORROSION PROTECTION

4-16

UNDERCOAT APPLICATION LOCATIONS

M4040003000167

The under parts of the body is undercoated for
anti-corrosive, anti-rust, anti-chipping, and anti-vibra-
tion performance.
After correcting the body, restore as shown in the
instructions of the figure, if necessary.

Tape the areas marked with an asterisks to protect
those areas from getting any undercoating on those
areas.

AB400024

AB

*

*

*

*

*

: Undercoat [Film thickness is at least 0.8 mm]

UNDERBODY ANTICORROSION AGENT LOCATIONS

CORROSION PROTECTION

4-17

UNDERBODY ANTICORROSION AGENT LOCATIONS

M4040009000068

In order to provide a greater corrosion resistance,
underbody corrosion prevention treatment should be
performed after undercoat application. After complet-
ing body repairs, restore this underbody corrosion
prevention treatment as indicated in the illustration if
necessary. Recommend wax:

• Tectyl 506T, 506 or S

• Waxoyl

NOTE:

.

•

Take care not to permit the anticorrosion agent to
come in contact with body painting, brake parts,
exhaust pipes, bearing seals for rear axle and
rubber parts (such as tires and drive shaft boots).

•

If anticorrosion agent gets onto the oxygen sen-
sor, it will cause a drop in the performance of the
sensor. Cover the oxygen sensor with a protec-
tive material when applying anti-corrosion agents
and undercoats.

AB300559AB

: 0.1 mm or more