Mitsubishi Lancer. Manual — part 271
GENERAL INFORMATION
POWER PLANT MOUNT
32-2
GENERAL INFORMATION
M1321000100340
The engine mounting system employs the inertial
axis four-point suspension method, which is field
proven.
• The optimised locations of the front and rear roll
mounts well distribute their loads thereby reduc-
ing engine idling vibrations.
• The fore-and-aft, liquid-filled engine mount of cyl-
inder type is adopted to reduce engine shake for
improved riding comfort.
CONSTRUCTION DIAGRAM
AC107318
Y0290AU
AC303563
Engine mounting
insulator
Transmission mounting insulator
Engine rear roll stopper bracket
Engine front roll stopper bracket
AB
SERVICE SPECIFICATION
POWER PLANT MOUNT
32-3
SERVICE SPECIFICATION
M1321000300333
Item
Standard value
Protruding length of stabilizer bar mounting bolt mm
22
± 1.5
SPECIAL TOOL
M1321000600378
Tool
Number
Name
Use
AC106827
MB991897
Ball joint remover
Knuckle and tie rod end ball joint
disconnection
NOTE: Steering linkage puller
(MB990635 or MB991113) is also
available to disconnect knuckle and
tie rod end ball joint.
ENGINE MOUNTING
POWER PLANT MOUNT
32-4
ENGINE MOUNTING
REMOVAL AND INSTALLATION
M1321001100440
CAUTION
*: Indicates parts which should be initially tightened, and then fully tightened after placing the vehicle
horizontally and loading the full weight of the engine on the vehicle body.
Pre-removal Operation
Raise the engine and transmission assembly until its weight
is not applied to the insulator, and support it securely.
AC303999
AC303968
AC304304AB
<4G1>
<4G6>
44 ± 10 N·m*
67 ± 7 N·m*
2
N
3
44 ± 10 N·m*
67 ± 7 N·m*
2
N
3
12 ± 2 N·m
1
Removal steps
1.
Pressure hose clamp <4G6>
2.
Self-locking nuts
3.
Engine Mounting Insulator
Removal steps (Continued)
TRANSMISSION MOUNTING
POWER PLANT MOUNT
32-5
TRANSMISSION MOUNTING
REMOVAL AND INSTALLATION
M1321001400430
CAUTION
*: Indicates parts which should be initially tightened, and then fully tightened after placing the vehicle
horizontally and loading the full weight of the engine on the vehicle body.
Pre-removal Operation
• Raise the engine and transmission assembly until its
weight is not applied to the insulator, and support it
securely.
• Battery and Battery tray Removal
• Air Cleaner Removal (Refer to GROUP 15, Air Cleaner
).
• Engine Rear Roll Stopper Bracket Removal (Refer to
).
Post-installation Operation
• Engine Rear Roll Stopper Bracket Installation (Refer to
).
• Air Cleaner Installation (Refer to GROUP 15, Air Cleaner
).
• Battery and Battery tray Installation
AC303988
AC303989
AC304258
<M/T>
<A/T>
AB
82 ± 7 N·m*
47 ± 7 N·m*
82 ± 7 N·m*
47 ± 7 N·m*
1
1
2
2
2
2
Removal steps
1.
Transmission mounting insulator
>>
A
<<
2.
Transmission mounting stopper
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст