Dodge Dakota (ND). Manual — part 1003
14. Remove dual retainer plate (2) from valve body.
Use special tool 6301 (1) to remove plate (2).
15. Remove regulator valve spring retainer (2).
21 - 404
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
ND
16. Remove remaining retainers (1, 2).
17. Remove all valves and springs.
18. Cleanliness through entire disassembly and assembly of the valve body cannot be overemphasized. When dis-
assembling, each part should be washed in a suitable solvent, then dried by compressed air. Do not wipe
Valve Body Assembly
1 - VALVE BODY
2 - T/C REGULATOR VALVE
3 - L/R SWITCH VALVE
4 - CONVERTER CLUTCH CONTROL VALVE
5 - MANUAL VALVE
6 - CONVERTER CLUTCH SWITCH VALVE
7 - SOLENOID SWITCH VALVE
8 - REGULATOR VALVE
ND
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
21 - 405
parts with shop towels. All mating surfaces in the valve body are accurately machined; therefore, careful han-
dling of all parts must be exercised to avoid nicks or burrs.
ASSEMBLY
NOTE: If the valve body assembly is being reconditioned or replaced, it is necessary to perform the Quick
Learn Procedure using the scan tool. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/TRANS-
MISSION CONTROL MODULE - STANDARD PROCEDURE)
1. Install all valves and springs as shown.
Valve Body Assembly
1 - VALVE BODY
2 - T/C REGULATOR VALVE
3 - L/R SWITCH VALVE
4 - CONVERTER CLUTCH CONTROL VALVE
5 - MANUAL VALVE
6 - CONVERTER CLUTCH SWITCH VALVE
7 - SOLENOID SWITCH VALVE
8 - REGULATOR VALVE
21 - 406
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
ND
2. Install regulator valve spring retainer (2).
3. Install dual retainer plate (2) using Tool 6301 (1).
ND
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
21 - 407
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст