Dodge Dakota (ND). Manual — part 239
4. Install the cable (5) pushpin into the left frame rail
(4).
5. Connect the starter solenoid wire harness connec-
tor (1).
6. Raise the vehicle on a hoist, (Refer to LUBRICA-
TION & MAINTENANCE/HOISTING - STANDARD
PROCEDURE).
7. Install the nut (2) securing the cable (1) to the
starter solenoid (3).
8. Connect the battery cable retaining pushpin (6)
securing the cable to the engine block.
9. Lower the vehicle.
10. Connect the battery positive cable terminal clamp
(8).
8F - 26
BATTERY SYSTEM
ND
11. Position the resonator (4) into the vehicle. Install
the bolts (3) into the air intake resonator (4) and
tighten the band clamp (2) on the air inlet tube (1).
12. Connect
the
battery
negative
cable
terminal
clamp.
13. Check the vehicle for normal operation.
BATTERY TRAY
DESCRIPTION
The molded plastic battery tray (3) is located in the left
front corner of the engine compartment. On this vehi-
cle, the battery tray also provides an anchor point for
the anti-lock brake controller (4), battery temperature
sensor (2) and the Integrated Power Module (IPM) (1).
The battery hold down hardware is contained within
the battery tray. A hole in the bottom of the battery tray
is fitted with a battery temperature sensor. (Refer to 8
-
ELECTRICAL/CHARGING/BATTERY
TEMPERA-
TURE SENSOR - DESCRIPTION) for additional infor-
mation on the battery temperature sensor.
ND
BATTERY SYSTEM
8F - 27
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the battery, (Refer to 8 - ELECTRICAL/
BATTERY SYSTEM/BATTERY - REMOVAL).
3. Remove the battery temperature sensor (2) from
the battery tray (3), (Refer to 8 - ELECTRICAL/
CHARGING/BATTERY TEMPERATURE SENSOR -
REMOVAL).
4. Remove the Integrated Power Module (IPM) (1),
(Refer to 8 - ELECTRICAL/POWER DISTRIBU-
TION/INTEGRATED
POWER
MODULE
-
REMOVAL).
5. Remove the Antilock Brake System (ABS) Hydrau-
lic Control Unit (HCU) (3) bolts (2) from the battery
tray (1).
6. Remove the battery negative cable retaining push-
pins (5) from the battery tray.
8F - 28
BATTERY SYSTEM
ND
7. Remove the engine compartment wire harness
retaining pushpins (3) from the battery tray (2).
8. Remove the left headlamp assembly, (Refer to 8 -
ELECTRICAL/LAMPS/LIGHTING
-
EXTERIOR/
HEADLAMP UNIT - REMOVAL).
9. Remove the battery tray bolts.
10. Remove the six upper battery tray bolts.
ND
BATTERY SYSTEM
8F - 29
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст