Dodge Dakota (ND). Manual — part 27
SPECIAL TOOLS
CLAMP INSTALLER C-4975A
3 - 24
HALF SHAFT
ND
C/V JOINT/BOOT-OUTER
REMOVAL
1. Place shaft in vise with soft jaws and support C/V
joint.
CAUTION: Do not damage C/V housing or half
shaft.
2. Remove clamps (2) (4) with a cut-off wheel or
grinder.
3. Slide the boot down the shaft.
4. Remove lubricant to expose the C/V joint snap
ring.
5. Spread snap ring (1) and slide the joint off the
shaft.
6. Slide boot off the shaft and discard old boot.
7. Mark alignment marks (1) on the inner race/hub
(2), bearing cage (3) and housing with dabs of
paint.
ND
HALF SHAFT
3 - 25
8. Clamp C/V joint in a vertical position in a soft
jawed vise.
9. Press down one side of the bearing cage (3) to
gain access to the ball at the opposite side.
NOTE: If joint is tight, use a hammer and brass
drift to loosen the bearing hub. Do not contact the
bearing cage with the drift.
10. Remove ball (4) from the bearing cage (3).
11. Repeat step above until all six balls are removed
from the bearing cage.
12. Lift cage and inner race (2) upward and out from
the housing (1).
13. Turn inner race 90° in the cage and rotate the
inner race/hub out of the cage.
3 - 26
HALF SHAFT
ND
INSTALLATION
1. Apply a light coat of grease to the C/V joint com-
ponents before assembling them.
2. Align inner race, cage and housing according to
the alignment reference marks.
3. Insert inner race (1) into the cage (2) and rotate
race into the cage.
4. Rotate inner race/hub in the cage (1).
5. Insert cage into the housing (3).
ND
HALF SHAFT
3 - 27
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст