Dodge Dakota (ND). Manual — part 445
U0172-LOST COMMUNICATION W/LEFT SIDE SATELLITE ACCELERATION SENSOR 1
8O - 376
RESTRAINTS - ELECTRICAL DIAGNOSTICS
ND
U0172-LOST COMMUNICATION W/LEFT SIDE SATELLITE ACCELERATION SENSOR 1 (CONTINUED)
For the Airbag System circuit diagram (Refer to 8 - ELECTRICAL/RESTRAINTS - SCHEMATICS AND DIAGRAMS).
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
The Occupant Restraint Controller (ORC) continuously communicates with the Left Side Impact Sensor 1 over
the sensor signal circuit. The sensor communication and on board diagnostics are powered by the ORC signal.
•
Set Condition:
This code will set, if the ORC and the Left Side Impact Sensor 1 do not establish and maintain valid data
communications.
Possible Causes
(R13) SIGNAL CIRCUIT SHORTED TO BATTERY
(R13) SIGNAL CIRCUIT SHORTED TO GROUND
(R13, R15) LEFT SIDE IMPACT SENSOR 1 CIRCUITS SHORTED TOGETHER
(R15) LEFT SIDE IMPACT SENSOR 1 GROUND CIRCUIT OPEN
(R13) LEFT SIDE IMPACT SENSOR 1 SIGNAL CIRCUIT OPEN
ORC, LEFT SIDE IMPACT SENSOR 1
Diagnostic Test
1.
VERIFY THAT DTC U0172-LOST COMMUNICATION W/LEFT SIDE SATELLITE ACCELERATION SENSOR 1
IS ACTIVE
NOTE: Ensure the battery is fully charged.
NOTE: When reconnecting Airbag system components, the ignition must be turned off and the battery must
be disconnected.
Turn the ignition on.
With the scan tool, read ORC DTCs.
Does the scan tool display active: U0172-LOST COMMUNICATION W/LEFT SIDE IMPACT SENSOR 1?
Yes
>> Go To 2
No
>> Go To 9
ND
RESTRAINTS - ELECTRICAL DIAGNOSTICS
8O - 377
U0172-LOST COMMUNICATION W/LEFT SIDE SATELLITE ACCELERATION SENSOR 1 (CONTINUED)
2.
CHECK THE (R13, R15) LEFT SIDE IMPACT SENSOR 1 SIGNAL AND GROUND CIRCUITS FOR A SHORT
TO BATTERY
WARNING: To avoid personal injury or death, turn the ignition off,
disconnect the battery and wait two minutes before proceeding.
Disconnect the Left front Impact Sensor 1 connector.
Disconnect the ORC connector.
WARNING: To avoid personal injury or death, turn the ignition on,
then reconnect the battery.
Measure the voltage of the (R13) Left Side Impact Sensor 1 Signal
circuit and (R15) Sensor Ground circuit at the Left Side Impact Sensor
1 connector and ground.
Is there any voltage present?
Yes
>> Repair the (R13, R15) Left Side Impact Sensor 1 circuits
for a short to battery.
Perform the ORC VERIFICATION TEST - VER 1.
No
>> Go To 3
3.
CHECK THE (R13) LEFT SIDE IMPACT SENSOR 1 SIGNAL CIRCUIT FOR A SHORT TO GROUND
WARNING: To avoid personal injury or death, turn ignition on,
then reconnect the battery.
Measure the resistance of the (R13) Left Side Impact Sensor 1 Signal
circuit between the Left Side Impact Sensor 1 connector and ground.
Is the resistance below 100K ohms?
Yes
>> Repair the (R13) Left Side Impact Sensor 1 Signal circuit
for a short to ground.
Perform the ORC VERIFICATION TEST - VER 1.
No
>> Go To 4
8O - 378
RESTRAINTS - ELECTRICAL DIAGNOSTICS
ND
U0172-LOST COMMUNICATION W/LEFT SIDE SATELLITE ACCELERATION SENSOR 1 (CONTINUED)
4.
CHECK THE (R13, R15) LEFT SIDE IMPACT SENSOR CIRCUITS FOR A SHORT TOGETHER
Measure the resistance between the (R13) Left Side Impact Sensor 1
Signal and (R15) Sensor Ground circuits at the Left Side Impact Sen-
sor 1 connector.
Is the resistance below 100K ohms?
Yes
>> Repair the (R13, R15) Left Side Impact Sensor 1 circuits
shorted together.
Perform the ORC VERIFICATION TEST - VER 1.
No
>> Go To 5
5.
CHECK THE (R15) LEFT SIDE IMPACT SENSOR 1 GROUND CIRCUIT FOR AN OPEN OR HIGH
RESISTANCE
Connect the 8443 Load Tool ORC Adaptor to the Occupant Control
Module connector.
Measure the resistance of the (R15) Left Side Impact Sensor 1
Ground circuit between the Left Side Impact Sensor 1 connector and
the 8443 Load Tool ORC Adaptor.
Is the resistance below 1 ohm?
Yes
>> Go To 6
No
>> Repair the (R15) Left Side Impact Sensor 1 Ground circuit
for an open or high resistance.
Perform the ORC VERIFICATION TEST - VER 1.
ND
RESTRAINTS - ELECTRICAL DIAGNOSTICS
8O - 379
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст