Dodge Dakota (ND). Manual — part 1150
20. Apply adhesive over the mesh around patch, and
smooth epoxy with a wide spreader to reduce fin-
ish grinding. Use two to three layers of mesh and
adhesive to create a stronger repair.
PATCHED PANEL SURFACING
After patch panel is installed, the patch area can be finished using the same methods as finishing other types of
body panels. If mesh material is exposed in the patched area, grind surface down, and apply a coat of high quality
rigid plastic body filler. Prime, block sand, and paint as required.
BUZZ, SQUEAK & RATTLE
Buzz, Squeak & Rattles (BSR) may be caused by any one or more of the following and may be corrected as indi-
cated:
•
Loose fasteners should be tightened to specifications.
•
Damaged or missing clips should be replaced.
•
Damaged trim panels should be replaced.
•
Incorrectly installed trim panels should be reinstalled properly.
Many BSR complaints such as loose trim, can be serviced using the Mopar
T
Parts BSR Noise Reduction Kit. This
kit contains various tapes including foam, flock and anti-squeak used to eliminate noises caused by metal, plastic
and vinyl components. Long life lubricants and greases can also be used on a variety of components. Refer to the
Buzz, Squeak & Rattle Kit table for material contents and usage.
23 - 12
BODY
ND
Buzz, Squeak & Rattle Kit
ITEM
FEATURES
APPLICATIONS
SERVICE TEMP
Itch And Squeak
Tape
An abrasion resistant material
thin enough to conform to most
irregular surfaces. Stops most
itches and squeaks.
Between metal and metal,
metal and plastic, metal and
vinyl, vinyl and plastic. Interior.
Examples: Trim panels and
bezels.
-40° to 225°
Fahrenheit
(-40° to 107°
Celsius)
Black Nylon Flock
Nylon Flock with an aggressive
acrylic adhesive. Provides for
cushioning and compression fit,
also isolates components.
Water-resistant.
Between metal and metal,
metal and plastic, vinyl and
plastic.
Examples: Pull cups, bezels,
clips, ducts, top cover to glass,
cowl panel.
-40° to 180°
Fahrenheit
(-40° to 82° Celsius)
High Density
Urethane Foam
Tear resistant, highly resilient
and durable.
Between metal and metal,
metal and plastic. Water-
resistant.
Examples: I/P, heavy metal
rattles, isolating brackets.
-40° to 180°
Fahrenheit
(-40° to 82° Celsius)
Open Cell Foam
Tape
Soft foam conforms to irregular
surfaces.
Wire harness and connector
wrap.
Examples: Seals, gasket,
wiring, heat ducts.
-40° to 180°
Fahrenheit
(-40° to 82° Celsius)
Closed Cell Low
Density Foam Tape
Soft, conformable. Water-
resistant.
Wherever bulk is needed.
Prevents closing flutters and
rattles when applied to door
watershield.
Examples: Door, I/P.
-40° to 180°
Fahrenheit
(-40° to 82° Celsius)
NYE
T
Grease 880
Long life.
Suspensions.
Examples: Strut busings, sway
bars.
-40° to 390°
Fahrenheit
(-40° to 200°
Celsius)
Krytox
T
Oil
Long life. Will not dry out or
harm plastics or rubber.
When access is not possible, oil
will migrate to condition. Vinyl,
rubber, plastic, metal.
Examples: Convertible top
bushings, pull cups trim panel
inserts.
-30° to 400°
Fahrenheit
(-34° to 205°
Celsius)
Krytox
T
Grease
Long life. Will not dry out or
harm plastics or rubber.
Vinyl, rubber, plastic, metal,
glass.
Examples: Weather-strips,
backlite and windshield
moldings.
-30° to 400°
Fahrenheit
(-34° to 205°
Celsius)
ND
BODY
23 - 13
SPECIAL TOOLS
BODY
Trim Stick C-4755
TORX BIT SET C-4794-B
REMOVER, MOLDINGS C-4829-A
Outer Belt Molding Remover - 9093
23 - 14
BODY
ND
DOOR - CARGO
TABLE OF CONTENTS
page
page
CABLE-LATCH
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
. . . . . . . . . . . . . . . . . . . . . . . . . 18
CHECK
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
. . . . . . . . . . . . . . . . . . . . . . . . . 21
DOOR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
. . . . . . . . . . . . . . . . . . . . . . . . . 23
. . . . . . . . . . . . . . . . . . . . . . . . 24
GLASS-DOOR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
. . . . . . . . . . . . . . . . . . . . . . . . . 33
HANDLE-SHUTFACE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
. . . . . . . . . . . . . . . . . . . . . . . . . 35
HINGE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36
. . . . . . . . . . . . . . . . . . . . . . . . . 38
LATCH-LOWER
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40
. . . . . . . . . . . . . . . . . . . . . . . . . 41
LATCH-UPPER
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42
. . . . . . . . . . . . . . . . . . . . . . . . . 43
PANEL-TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
. . . . . . . . . . . . . . . . . . . . . . . . . 45
STRIKER-LOWER LATCH
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 46
. . . . . . . . . . . . . . . . . . . . . . . . . 46
. . . . . . . . . . . . . . . . . . . . . . . . 47
STRIKER-UPPER LATCH
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47
. . . . . . . . . . . . . . . . . . . . . . . . . 48
. . . . . . . . . . . . . . . . . . . . . . . . 48
WATERSHIELD
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 49
. . . . . . . . . . . . . . . . . . . . . . . . . 49
CABLE-LATCH
REMOVAL
CAUTION: Do not allow the watershield or adhe-
sive to become contaminated with dirt or other
foreign substances.
Do not damage the watershield during removal
and installation.
If the watershield becomes contaminated or dam-
aged, replace the watershield.
1. Remove the watershield. (Refer to 23 - BODY/
DOOR - CARGO/WATERSHIELD - REMOVAL)
ND
DOOR - CARGO
23 - 15
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст