Dodge Dakota (ND). Manual — part 840
6. Install transmission to engine mounting bolts (3).
Tighten the bolts to 41 N·m (30 ft. lbs.).
7. Install torque converter bolts (3).
9 - 898
ENGINE - 4.7L SERVICE INFORMATION
ND
8. Connect both left (2) and right (3) side body ground
straps.
9. Position generator wiring behind the oil dipstick
tube, then install the oil dipstick tube upper mount-
ing bolt.
10. Install power steering pump.
11. Connect fuel supply line quick connect fitting
(Refer to 14 - FUEL SYSTEM/FUEL DELIVERY/
QUICK CONNECT FITTING - STANDARD PRO-
CEDURE).
12. Connect the vacuum lines at the throttle body and
intake manifold.
ND
ENGINE - 4.7L SERVICE INFORMATION
9 - 899
13. Connect engine harness at the following points:
•
Intake Air Temperature (IAT) Sensor (4)
•
Idle Air Control (IAC) Motor (3)
•
Fuel Injectors
•
Throttle Position (TPS) Switch (2)
•
Engine Oil Pressure Switch
•
Engine Coolant Temperature (ECT) Sensor
•
Manifold Absolute Pressure (MAP) Sensor
•
Camshaft Position (CMP) Sensor
•
Coil Over Plugs
14. Position and install heater hoses (1) and tubes
onto intake manifold.
15. Install the heater hoses onto the heater core and
the engine front cover, and install clips (2).
9 - 900
ENGINE - 4.7L SERVICE INFORMATION
ND
16. Install generator (3) (Refer to 8 - ELECTRICAL/
CHARGING/GENERATOR - INSTALLATION).
17. Install A/C condenser (Refer to 24 - HEATING &
AIR
CONDITIONING/PLUMBING/A/C
CON-
DENSER - INSTALLATION), radiator (Refer to 7 -
COOLING/ENGINE/RADIATOR - INSTALLATION)
and transmission oil cooler.
18. Connect radiator upper and lower hoses.
19. Connect the transmission oil cooler lines to the
radiator.
20. Install accessory drive belt (Refer to 7 - COOL-
ING/ACCESSORY
DRIVE/DRIVE
BELTS
-
INSTALLATION), fan assembly and shroud (Refer
to 7 - COOLING/ENGINE/FAN DRIVE VISCOUS
CLUTCH - INSTALLATION).
21. Install A/C compressor (2) (Refer to 24 - HEAT-
ING
&
AIR
CONDITIONING/PLUMBING/A/C
COMPRESSOR - INSTALLATION).
22. Install both breathers (1). Connect tube to both
crankcase breathers.
23. Connect throttle and speed control cables.
24. Install throttle body resonator assembly and air
inlet hose. Tighten clamps 4 N·m (35 in. lbs.).
ND
ENGINE - 4.7L SERVICE INFORMATION
9 - 901
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст