Dodge Dakota (ND). Manual — part 171
U0019–CAN B BUS
8A - 142
AUDIO/VIDEO SYSTEMS - ELECTRICAL DIAGNOSIS
ND
U0019–CAN B BUS (CONTINUED)
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
Continuously.
•
Set Condition:
Whenever the Can B Bus (+) or B Bus (–) circuit is open, shorted to voltage or shorted to ground, this code
will set.
Possible Causes
CAN B BUS DTCs IN FRONT CONTROL MODULE
(D54) CAN B BUS (–) CIRCUIT OPEN
(D55) CAN B BUS (+) CIRCUIT OPEN
AMPLIFIER
Diagnostic Test
1.
TEST FOR INTERMITTENT CONDITION
Turn the ignition on.
With the scan tool, record and erase DTCs
Cycle the ignition from on to off 3 times.
Turn the ignition on.
With the scan tool, read DTCs.
Does the scan tool display U0019–CAN B BUS CIRCUIT?
Yes
>> Go To 2
No
>> The conditions that caused this code to set are not
present at this time. Using the wiring diagram/schematic
as a guide, inspect the wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1.
2.
CHECK FRONT CONTROL MODULE DTCs
With the scan tool, read Front Control Module DTCs
Does the scan tool display any CAN B BUS DTCs – ACTIVE?
Yes
>> Refer to the symptom list for problems related to Communication in the ELECTRICAL.– ELECTRONIC
CONTROL MODULES – ELECTRICAL DIAGNOSES section.
No
>> Go to 3
ND
AUDIO/VIDEO SYSTEMS - ELECTRICAL DIAGNOSIS
8A - 143
U0019–CAN B BUS (CONTINUED)
3.
CAN B BUS (+) CIRCUIT OPEN
Turn the ignition off.
Disconnect the Amplifier harness connector.
Disconnect the Front Control Module C1 harness connector.
Measure the resistance of the (D55) Can B Bus (+) circuit between the
Front Control Module C1 harness connector and the Amplifier harness
connector.
Is the resistance below 2.0 ohms?
Yes
>> Go To 4
Perform BODY VERIFICATION TEST - VER 1.
No
>> Repair the Can B Bus (+) circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
8A - 144
AUDIO/VIDEO SYSTEMS - ELECTRICAL DIAGNOSIS
ND
U0019–CAN B BUS (CONTINUED)
4.
CAN B BUS (–) CIRCUIT OPEN
Measure the resistance of the (D54) Can B Bus (–) circuit between the
Front Control Module C1 harness connector and the Amplifier harness
connector.
Is the resistance below 2.0 ohms?
Yes
>> Replace the Amplifier in accordance with the service infor-
mation..
Perform BODY VERIFICATION TEST - VER 1.
No
>> Repair the Can B Bus (–) circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
ND
AUDIO/VIDEO SYSTEMS - ELECTRICAL DIAGNOSIS
8A - 145
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст