Dodge Dakota (ND). Manual — part 62
7. Remove the inboard brake pad (4) from the caliper
adapter (1).
8. Remove the outboard brake pad (2) from the cali-
per adapter (1).
9. Remove the anti-rattle clips (1) from the pad (2).
REAR BRAKE SHOES
1. Raise and support vehicle.
2. Remove wheel and tire assembly.
3. Remove clip nuts securing brake drum to wheel studs.
4. Remove drum. If drum is difficult to remove, remove rear plug from access hole in support plate. Back-off self
adjusting by inserting a thin screwdriver into access hole and push lever away from adjuster star wheel. Then
insert an adjuster tool into brake adjusting hole rotate adjuster star wheel to retract brake shoes.
5. Vacuum brake components to remove brake lining dust.
5 - 18
BRAKES - BASE
ND
6. Remove shoe return spring (3) with brake spring
plier tool.
7. Remove adjuster spring and lever (5). Disengage
lever from spring by sliding lever forward to clear
pivot and work lever out from under spring.
8. Disengage and remove shoe return spring (1) from
brake shoes. (3)
9. Remove brake shoe hold down clips (6).
10. Remove rear brake shoe (7) from support plate
(9).
11. Remove front brake shoe (8) from support plate
(9).
12. Remove park brake lever (2) from the brake shoe.
ND
BRAKES - BASE
5 - 19
CLEANING
Clean the individual brake components, including the support plate and wheel cylinder exterior, with a water damp-
ened cloth or with brake cleaner. Do not use any other cleaning agents. Remove light rust and scale from the brake
shoe contact pads on the support plate with fine sandpaper.
INSTALLATION
FRONT DISC BRAKE PADS
1. Bottom pistons in caliper bore with C-clamp. Place
an old brake shoe between a C-clamp and caliper
piston.
2. Clean caliper mounting adapter.
3. Install new anti-rattle clips (1) to the brake pads
(2).
4. Install inboard brake pad (4) in adapter (1).
5. Install outboard brake pad (2) in adapter (1).
5 - 20
BRAKES - BASE
ND
6. Install the caliper (1) over rotor, Then push the cal-
iper onto the adapter (2).
7. Install caliper slide pin bolts (4), (Refer to 5 -
BRAKES/HYDRAULIC/MECHANICAL/DISC
BRAKE CALIPERS - INSTALLATION).
8. Install wheel and tire assemblies and lower vehicle,
(Refer to 22 - TIRES/WHEELS/WHEELS - STAN-
DARD PROCEDURE).
9. Apply brakes several times to seat caliper pistons
and brake shoes and obtain firm pedal.
10. Top off master cylinder fluid level.
REAR BRAKE SHOES
1. Clean and inspect individual brake components.
2. Lubricate where the brake shoe contacts the support plate with high temperature grease or Lubriplate.
3. Lubricate adjuster screw socket, nut, button and screw thread surfaces with grease or Lubriplate.
ND
BRAKES - BASE
5 - 21
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст