Dodge Dakota (ND). Manual — part 1136

BEARINGS AND SEALS

1. Remove snap-ring (1) that retains front output shaft

front bearing in case. Then remove bearing. Use
hammer handle, or hammer and brass punch to
tap bearing out of case.

2. Install new front output shaft front bearing with Tool

Handle C-4171(1) and Installer 8033-A (2) with the
tapered cone upward.

21 - 936

TRANSFER CASE - NV244

ND

3. Install front bearing snap-ring (1).

4. Install new front output shaft oil seal with Installer

6952-A (1).

5. Install snap-ring on new input shaft bearing.

ND

TRANSFER CASE - NV244

21 - 937

6. Remove input shaft bearing with Tool Handle C-4171 (1) and Remover C-4210 (2).

7. Install new input shaft bearing (2) with Tool Handle

C-4171 and Remover C-4210. Install bearing far
enough to seat snap-ring (1) against case.

8. Remove the input gear pilot bearing by inserting a

suitably sized drift (1) into the splined end of the
input gear (2) and driving the bearing out with the
drift and a hammer.

21 - 938

TRANSFER CASE - NV244

ND

9. Install new pilot bearing with Installer 8128 (2) and

Handle C-4171 (1).

10. Install new seal in front bearing retainer (1) with

Installer 7884 (2).

ND

TRANSFER CASE - NV244

21 - 939