Chrysler Le Baron, Dodge Dynasty, Plymouth Acclaim. Manual — part 101
CAUTION: Before removing the gearshift housing,
reverse the lock pin (so the long end is down) and
insert lock pin into the same threaded hole. This
procedure will save time when the gearshift hous-
ing assembly is reinstalled.
Fig. 14 A-523/A-543/A-568 Shift Forks and Shift Rail Components
Fig. 15 Gearshift Housing Bolts
Fig. 16 Gearshift Housing Removed
21 - 10
TRANSAXLE
Ä
To install gearshift housing, be sure to reverse
the lock pin in the housing to lock the selector
shaft in the 3-4 neutral position.
CAUTION: Install roller detents so roller and slots are
parallel with shift rails.
Remove or install 3-4 lug roll pin, 3-4 fork roll pin,
and reverse lug roll pin using the above procedure.
CAUTION: If any roll pin falls out, retrieve roll pin from
bottom of case.
Fig. 19 Install 1-2 Shift Lug Roll Pin
Fig. 20 Remove 1-2 Shift Fork Roll Pin
Fig. 21 Reverse Pivot Lever
Fig. 17 Remove Roller Detents
Fig. 18 Remove 1-2 shift Lug Roll Pin
Ä
TRANSAXLE
21 - 11
Fig. 22 5th Shift Rail C-Clip
Fig. 23 5th Shift Rail and Shift Lug
Fig. 24 5th Shift Lug with Interlock Pin
Fig. 25 5th Shift Lug Properly Installed
Fig. 26 Reverse Shift Rail and Shift Lug
Fig. 27 3-4 Shift Rail and Shift Lug
21 - 12
TRANSAXLE
Ä
CAUTION: Pry only at slot as shown (Fig. 30).
Fig. 28 1-2 Shift Rail and Shift Lug
Fig. 29 Remove or Install Large Snap Ring
Fig. 30 Pry Bearing Retainer Plate to Remove
Fig. 31 Bearing Support Plate
Fig. 32 Remove or Install Reverse Idler Gear
Fig. 33 Reverse Idler Gear Assembly
Ä
TRANSAXLE
21 - 13
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст