Dodge Durango (HB). Manual — part 338
B1608-HEADLAMP SWITCH INPUT CIRCUIT HIGH
HB
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
8L - 71
B1608-HEADLAMP SWITCH INPUT CIRCUIT HIGH (CONTINUED)
For the Exterior Lighting system circuit diagram (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR -
SCHEMATICS AND DIAGRAMS).
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
•
Set Condition:
Possible Causes
HEADLAMP SWITCH
(L900) HEADLAMP MUX RETURN CIRCUIT
(L307) HEADLAMP MUX INPUT CIRCUIT
INSTRUMENT CLUSTER
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
Diagnostic Test
1.
INTERMITTENT CONDITION
Turn the ignition on.
With the Scan Tool, clear all CCN DTC’s.
Turn the Headlamps on.
With the Scan Tool, read the DTC information.
Does the Scan Tool read: B1608-HEADLAMP SWITCH INPUT CIRCUIT HIGH?
Yes
>> Go To 2
No
>> The condition that caused the symptom is currently not present. Inspect the related wiring for a possible
intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
Perform the BODY VERIFICATION TEST — VER 1.
2.
HEADLAMP SWITCH
Disconnect the Headlamp Switch connector.
Turn the ignition on.
Measure the voltage between the (L900) Headlamp MUX Return circuit and (L307) Headlamp Input MUX circuit.
Does the voltage read 0.0 volts?
Yes
>> Replace the Headlamp Switch in accordance with the service information.
Perform the BODY VERIFICATION TEST — VER 1.
No
>> Go To 3
8L - 72
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
HB
B1608-HEADLAMP SWITCH INPUT CIRCUIT HIGH (CONTINUED)
3.
(L900) MUX RETURN CIRCUIT
Turn the ignition off.
Disconnect the Headlamp Switch connector.
Disconnect the Instrument Cluster C2 connector.
Measure the resistance of the (L900) Headlamp MUX Return circuit.
Is the resistance below 5.0 ohms?
Yes
>> Go To 4
No
>> Repair the (L900) Headlamp MUX Return circuit.
Perform the BODY VERIFICATION TEST — VER 1.
4.
INSTRUMENT CLUSTER
Turn the ignition off.
Disconnect the Headlamp Switch connector.
Disconnect the Instrument Cluster C2 connector.
Measure the resistance of the (L307) Headlamp MUX circuit.
Is the resistance below 5.0 ohms?
Yes
>> Replace the instrument Cluster in accordance with the ser-
vice information.
Perform the BODY VERIFICATION TEST — VER 1.
No
>> Repair the (L307) Headlamp MUX circuit.
Perform the BODY VERIFICATION TEST — VER 1.
HB
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
8L - 73
SCHEMATICS AND DIAGRAMS
EXTERIOR
LIGHTING
SCHEMA
TIC
8L - 74
LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст