Dodge Durango (HB). Manual — part 1051
31. Remove the axle isolator bracket (2).
32. Remove the structural cover.
33. Disconnect the right and left exhaust pipes at the
manifolds and from the crossover, and remove
from the vehicle.
NOTE: The exhaust clamps at the manifolds can-
not be reused. New clamps must be used or leaks
may occur.
HB
ENGINE - 4.7L SERVICE INFORMATION
9 - 1203
34. Remove torque convertor bolts (3), and mark
location for reassembly.
35. Remove transmission bellhousing to engine bolts
(3).
36. Remove left and right engine mount thru bolts (3).
37. Lower the vehicle.
38. Support the transmission with a suitable jack.
39. Connect a suitable engine hoist to the engine lift
plate.
40.
Remove engine from vehicle.
9 - 1204
ENGINE - 4.7L SERVICE INFORMATION
HB
INSTALLATION - ENGINE
1. Position the engine in the vehicle.
2. Install
the
transmission
bellhousing
to
engine
mounting bolts (3). Tighten the bolts to 41 N·m
(30ft. lbs.)
3. Install the engine mount thru bolts (3).
HB
ENGINE - 4.7L SERVICE INFORMATION
9 - 1205
4. Install the torque convertor bolts (3).
5. Install the starter (2).
6. Connect the crankshaft position sensor.
7. Install the engine block heater power cable, if
equipped.
9 - 1206
ENGINE - 4.7L SERVICE INFORMATION
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст