Dodge Durango (HB). Manual — part 62
REAR
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Drain a small amount of fluid from master cylinder
brake reservoir with a clean suction gun.
4. Bottom the caliper pistons into the caliper by prying
the caliper over.
5. Remove the caliper mounting bolts.
6. Remove the disc brake caliper from the mount.
CAUTION: Never allow the disc brake caliper to
hang from the brake hose. Damage to the brake
hose will result. Provide a suitable support to
hang the caliper securely.
7. Remove the inboard and outboard brake pads (1).
8. Remove the anti-rattle clips (2).
9. Remove the caliper adapter mounting bolts (4).
INSTALLATION
FRONT
1. Install the caliper adapter (1) to the steering
knuckle.
2. Install the caliper adapter mounting bolts (2) and
tighten to 176 N·m (130 ft.lbs.).
3. Install the disc brake caliper (1) (Refer to 5 -
BRAKES/HYDRAULIC/MECHANICAL/DISC
BRAKE CALIPERS - INSTALLATION).
4. Install the tire and wheel assembly (Refer to 22 -
TIRES/WHEELS/WHEELS - STANDARD PROCE-
DURE).
5. Remove the support and lower the vehicle.
HB
BRAKES - BASE
5 - 27
REAR
1. Install the caliper adapter mounting bolts (4).
Tighten the mounting bolts to 135 N·m (100 ft.lbs).
2. Install the anti-rattle clips (2).
3. Install the inboard and outboard pads (1).
4. Install the caliper mounting bolts.
5. Install the tire and wheel assembly.
DISC BRAKE CALIPER ADAPTER MOUNT
REMOVAL - REAR
1. Remove wheel and tire assembly.
2. Remove the disc brake caliper (3) (Refer to 5 -
BRAKES/HYDRAULIC/MECHANICAL/DISC
BRAKE CALIPERS - REMOVAL).
3. Remove the caliper adapter (2) (Refer to 5 -
BRAKES/HYDRAULIC/MECHANICAL/DISC
BRAKE CALIPER ADAPTER - REMOVAL).
4. Remove the rotor (1) (Refer to 5 - BRAKES/HY-
DRAULIC/MECHANICAL/ROTORS - REMOVAL).
5. Remove the axle shaft (1) (Refer to 3 - DIFFER-
ENTIAL & DRIVELINE/REAR AXLE - 9 1/4/AXLE
SHAFTS - REMOVAL).
5 - 28
BRAKES - BASE
HB
6. Remove the park brake shoes (1) (Refer to 5 -
BRAKES/PARKING BRAKE/SHOES - REMOVAL).
7. Remove the parking brake cable (2) from the brake
lever (1).
8. Remove the bolts (2) attaching the support plate to
the axle and remove the support plate (1).
HB
BRAKES - BASE
5 - 29
9. Remove the caliper adapter mount (1) from the
axle housing (2).
INSTALLATION
1. Install the caliper adapter mount (1) on the axle
housing (2).
2. Install support plate (1) on axle flange. Tighten
attaching bolts (2) to 115 N·m (85 ft. lbs.).
5 - 30
BRAKES - BASE
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст