Dodge Durango (HB). Manual — part 53
6. Tighten bearing cap bolts (2) to 136 N·m (100
ft.lbs.). Install adjuster locks and tight adjuster lock
bolts (3) to 10 N·m (95 in. lbs.).
7. Install axle shafts.
BEARINGS-DIFFERENTIAL CASE
REMOVAL
1. Remove differential case from axle housing.
2. Remove differential bearings from the case with
Puller/Press C-293-PA (1) Adapters C-293-47 (2)
and Plug C-293-3 (5).
HB
REAR AXLE - 9 1/4
3 - 139
INSTALLATION
1. Install differential side bearings (3) with Installer
C-4213 (4) and Handle C-4171 (1).
2. Install differential case into housing.
GEAR-PINION/RING/TONE RING
REMOVAL
NOTE: The ring gear and pinion are serviced in a matched set. Never replace one gear without replacing the
other matching gear.
1. Remove differential from differential housing.
2. Place differential case in a vise with soft metal jaw protectors.
3. Remove ring gear bolts and drive ring gear (2) off
the differential case (1) with a soft hammer (3).
4. Install bolts into two of the threaded holes in the pinion flange 180° apart.
5. Position Holder 6719 against flange and install a bolt and washer into one of the remaining threaded holes.
Tighten bolts so the Holder 6719 is held to the flange.
3 - 140
REAR AXLE - 9 1/4
HB
6. Use Holder 6719 to hold flange and remove the companion flange nut and washer.
7. Remove flange (1) from pinion with Remover
C-452 (2).
8. Remove pinion from housing with a soft hammer
(1).
9. Remove pinion seal with a pry tool or slide-hammer mounted screw.
10. Remove oil slinger if equipped and front pinion bearing.
HB
REAR AXLE - 9 1/4
3 - 141
11. Remove front pinion bearing cup with Remover
C-4345 (1) and Handle C-4171 (2).
12. Remove rear bearing cup from housing with
Remover C-4307 (1) and Handle C-4171 (2).
3 - 142
REAR AXLE - 9 1/4
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст