Dodge Durango (HB). Manual — part 1311
24. Connect the wiring harness connector to the line
pressure sensor (2).
CAUTION: It is essential that correct length bolts
be used to attach the converter to the driveplate.
Bolts that are too long will damage the clutch sur-
face inside the converter.
25. Install torque converter-to-driveplate bolts. Tighten
bolts to 31 N·m (270 in. lbs.).
26. Install starter motor and cooler line bracket.
27. Connect cooler lines to transmission.
28. Install transmission fill tube.
29. Install exhaust components.
30. Install the structural dust cover (2) onto the trans-
mission and the engine. (Refer to 9 - ENGINE/
ENGINE
BLOCK/STRUCTURAL
COVER
-
INSTALLATION)
HB
AUTOMATIC TRANSMISSION 545RFE - SERVICE INFORMATION
21 - 649
31. Align and install the front propeller shaft, if neces-
sary. (Refer to 3 - DIFFERENTIAL & DRIVELINE/
PROPELLER
SHAFT
-
FRONT/PROPELLER
SHAFT - INSTALLATION)
32. Align and install the rear propeller shaft. (Refer to
3 - DIFFERENTIAL & DRIVELINE/PROPELLER
SHAFT - REAR/PROPELLER SHAFT - INSTAL-
LATION)
33. Adjust gearshift cable if necessary.
34. Install any skid plates (1) removed previously.
(Refer to 13 - FRAMES & BUMPERS/FRAME/
TRANSFER CASE SKID PLATE - INSTALLA-
TION)
35. Lower vehicle.
36. Fill transmission with Mopar
T
ATF +4, Automatic
Transmission Fluid.
21 - 650
AUTOMATIC TRANSMISSION 545RFE - SERVICE INFORMATION
HB
SCHEMATICS AND DIAGRAMS
HYDRAULIC SCHEMATICS
HYDRAULIC
FLOW
IN
P
ARK/NEUTRAL
HB
AUTOMATIC TRANSMISSION 545RFE - SERVICE INFORMATION
21 - 651
HYDRAULIC
FLOW
IN
NEUTRAL
OVER
8MPH
21 - 652
AUTOMATIC TRANSMISSION 545RFE - SERVICE INFORMATION
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст