Dodge Durango (HB). Manual — part 368
6. Place a piece of paper approximately 22 by 28 centimeters (8.5 by 11 inches), oriented on the vehicle lengthwise
from front to rear, on the center line of the roof at the windshield header. The purpose of the paper is to protect
the roof panel from scratches, and to define the area to be demagnetized.
7. Connect the degaussing tool to an electrical outlet, while keeping the tool at least 61 centimeters (2 feet) away
from the compass unit.
8. Slowly approach the center line of the roof panel at the windshield header, with the degaussing tool connected.
9. Contact the roof panel with the plastic coated tip of the degaussing tool. Be sure that the template is in place to
avoid scratching the roof panel. Using a slow, back-and-forth sweeping motion, and allowing 13 millimeters (0.50
inch) between passes, move the tool at least 11 centimeters (4 inches) to each side of the roof center line, and
28 centimeters (11 inches) back from the windshield header.
10. With the degaussing tool still energized, slowly back it away from the roof panel. When the tip of the tool is at
least 61 centimeters (2 feet) from the roof panel, disconnect the tool.
11. Calibrate the compass and adjust the compass variance. Refer to Compass Variation Adjustment and Com-
pass Calibration in the Service Procedures section of this group for the procedures.
REMOVAL
OVERHEAD CONSOLE
1. Disconnect and isolate the battery negative cable.
2. Insert the fingertips of both hands between the
headliner and the sides of the overhead console
housing (1).
HB
OVERHEAD CONSOLE - SERVICE INFORMATION
8M - 25
3. Pull downward on the sides of the overhead con-
sole housing firmly and evenly to disengage the
snap clips from the overhead console bracket (2).
4. Lower the overhead console (4) from the headliner
far enough to access the wire harness connectors
(3).
5. Disconnect the roof wire harness connectors (3)
from the overhead console wire harness connector.
6. Remove
the
overhead
console
(4)
from
the
headliner.
8M - 26
OVERHEAD CONSOLE - SERVICE INFORMATION
HB
OVERHEAD CONSOLE BRACKET
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console (1) from the over-
head console bracket.(Refer to 8 - ELECTRICAL/
OVERHEAD CONSOLE - REMOVAL).
3. Remove the two screws (4) that secure the front of
the overhead console bracket (2) to the roof front
header.
4. Remove the overhead console bracket (2) from the
headliner (1) by moving it back and forth to free it
from it’s seat.
HB
OVERHEAD CONSOLE - SERVICE INFORMATION
8M - 27
INSTALLATION
OVERHEAD CONSOLE
1. Position the overhead console (1) near the mount-
ing location on the headliner.
2. Reconnect the roof wire harness connector (3) to
the overhead console wire harness connector.
3. Align the snap clips (1) on the overhead console
housing with their receptacles in the overhead con-
sole bracket.
4. Push upward firmly and evenly on the sides of the
overhead console housing over the snap clip loca-
tions until the snap clip is fully engaged with its
receptacle in the overhead console bracket.
5. Reconnect the battery negative cable.
8M - 28
OVERHEAD CONSOLE - SERVICE INFORMATION
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст