Dodge Durango (HB). Manual — part 1397
GRILLE-DEFROSTER
REMOVAL
1. Before proceeding with the following repair procedure, review all warnings and cautions. (Refer to 23 - BODY/
INSTRUMENT PANEL - WARNING)
2. Using a trim stick C-4755 or equivalent, remove the drivers side a-pillar trim.
3. Open the trim covers in the passenger side a-pillar grab handle and remove the bolts.
4. Remove the right a-pillar trim panel.
5. Using a trim stick C-4755 or equivalent, remove the instrument panel defroster grille.
6. Disconnect the sensor electrical connector (2).
7. Remove the screw (4) and remove the sun sensor (1).
HB
INSTRUMENT PANEL
23 - 101
INSTALLATION
1. Before proceeding with the following repair procedure, review all warnings and cautions. (Refer to 23 - BODY/
INSTRUMENT PANEL - WARNING)
2. Install the sun sensor (1) and install the screw (4).
3. Position the defroster grille (2) into place and connect the electrical connector (3).
4. Position the drivers side a-pillar trim into place and seat the retaining clips fully.
5. Position the passenger side a-pillar trim panel into place and seat fully.
6. Install the bolts and tighten to 6 N·m (55 in. lbs.).
ASSEMBLY-INSTRUMENT PANEL
REMOVAL
WARNING: TO AVOID PERSONAL INJURY OR DEATH, ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE
THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING
COLUMN, AIRBAG, OCCUPANT CLASSIFICATION SYSTEM, SEAT BELT TENSIONER, IMPACT SENSOR, OR
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY
NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE
BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE
THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, NEVER STRIKE OR DROP THE OCCUPANT
RESTRAINT CONTROLLER, AS IT CAN DAMAGE THE IMPACT SENSOR OR AFFECT ITS CALIBRATION. THE
OCCUPANT RESTRAINT CONTROLLER CONTAINS THE IMPACT SENSOR, WHICH ENABLES THE SYSTEM
TO DEPLOY THE SUPPLEMENTAL RESTRAINTS. IF AN AIRBAG CONTROL MODULE IS ACCIDENTALLY
DROPPED DURING SERVICE, THE MODULE MUST BE SCRAPPED AND REPLACED WITH A NEW UNIT.
FAILURE TO OBSERVE THIS WARNING COULD RESULT IN ACCIDENTAL, INCOMPLETE, OR IMPROPER
SUPPLEMENTAL RESTRAINT DEPLOYMENT.
23 - 102
INSTRUMENT PANEL
HB
CAUTION: On vehicles equipped with the Occupant Classification System (OCS), never replace both the
Occupant Restraint Controller (ORC) and the Occupant Classification Module (OCM) at the same time. If
both require replacement, replace one. Then perform the supplemental restraint verification test before
replacing the other. Both the ORC and the OCM store OCS calibration data, which they transfer to one
another when one of them is replaced. If both are replaced at the same time, an irreversible fault will be set
in both modules.
1. Before proceeding with the following repair proce-
dure, review all warnings and cautions. (Refer to
23 - BODY/INSTRUMENT PANEL - WARNING)
2. Disconnect and isolate battery negative cable.
3. Using a trim stick C-4755 or equivalent, remove the
left door sill trim cover.
4. Remove the screw and remove the left cowl trim
cover.
5. Remove the left instrument panel end cap.
6. Remove the two screws (1) and remove the steer-
ing column opening cover (2).
7. Remove the screws (5) and position aside the
hood release handle (2).
HB
INSTRUMENT PANEL
23 - 103
8. Remove the four screws (2) and remove the steer-
ing column opening reinforcement (1).
9. Remove the steering column tilt lever.
10. Remove the upper (1) and lower (3) column
shrouds.
11. Disconnect the wiring harness connectors (1) to
the column.
12. Remove the shift cable from the column shift lever
actuator. (Refer to 21 - TRANSMISSION/TRANS-
AXLE/AUTOMATIC/GEAR
SHIFT
CABLE
-
REMOVAL)
13. Release the shift cable from the column bracket
and remove it from the bracket.
14. Remove the SKIM module in order to disconnect
the electrical connector.
23 - 104
INSTRUMENT PANEL
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст