Dodge Durango (HB). Manual — part 1427
7. Loosen fasteners (3) attaching sunroof assembly.
8. With the aid of a helper, support the sunroof and remove the fasteners attaching sunroof assembly (4) to roof
panel (1).
9. Remove the sunroof (4) from vehicle.
INSTALLATION
1. Verify that u-nuts (1) are in position in the roof bow
#2 (2).
2. Verify that glass panel is loose and slightly
retracted.
HB
SUNROOF
23 - 221
3. Raise sunroof module assembly (4) and guide it carefully into position.
4. While supporting the sunroof assembly, start the 12
attaching screws, three along each side rail, two
along the front trough and four along the motor
bracket.
5. Position special tool # 9582 pins (3) through the
locating holes (2) and confirm the module assem-
bly (1) is properly aligned.
23 - 222
SUNROOF
HB
6. Tighten the attaching screws to 6 N·m (53 in. lbs.)
using the sequence shown.
7. Remove the alignment tool (1) from the alignment
holes (2).
8. Connect the electrical connector (4).
HB
SUNROOF
23 - 223
9. Connect the drain tubes to the sunroof (1).
10. Position the video display support bracket (2), if
equipped, and install the bolts (1 & 4). Tighten the
bolts to 6 N·m (53 in. lbs.).
11. Connect battery negative cable.
12. Test sunroof operation, adjust if necessary. (Refer
to
23
-
BODY/SUNROOF/GLASS
PANEL
-
ADJUSTMENTS)
13. Install headliner. (Refer to 23 - BODY/INTERIOR/
HEADLINER - INSTALLATION)
23 - 224
SUNROOF
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст