Dodge Durango (HB). Manual — part 1424
6. Remove tube (2), as necessary.
REAR HOUSING HOSE
1. Move glass panel to the fully closed position.
2. Disconnect negative battery cable.
3. Remove headliner (Refer to 23 - BODY/INTERIOR/
HEADLINER - REMOVAL).
4. Disconnect the drain hose from the sunroof hous-
ing (1).
5. Drain any liquid from hose connection, if necessary.
6. Release the push pin fasteners (1) and remove the
tube (2).
HB
SUNROOF
23 - 209
INSTALLATION
FRONT HOSES
1. Connect the new drain hose (2) to the sunroof
housing (1) and test drainage.
2. Install headliner (Refer to 23 - BODY/INTERIOR/
HEADLINER - INSTALLATION).
3. Verify sunroof operation and alignment.
REAR HOUSING HOSE
1. Install the rear hose (2) and seat the push pin fas-
teners (1) fully.
23 - 210
SUNROOF
HB
2. Connect the new drain hose (1) to the sunroof
housing and test drainage.
3. Install the quarter trim panels. (Refer to 23 -
BODY/INTERIOR/QUARTER
PANEL
TRIM
-
INSTALLATION)
4. Install headliner (Refer to 23 - BODY/INTERIOR/
HEADLINER - INSTALLATION).
5. Connect the control switch wire connector and
install control switch.
6. Verify sunroof operation and alignment.
MOTOR
STANDARD PROCEDURE - INITIALIZATION
1. To initialize the motor, connect power to the sunroof.
2. Press the close-button until the glass panel has reached the full closed position.There will be a slight “kick” of the
glass panel when initialization occurs if the glass panel starts in the full closed position.The “kick” is accompanied
by a soft tick noise.
HB
SUNROOF
23 - 211
REMOVAL
1. Remove the sunroof (Refer to 23 - BODY/SUNROOF/MODULE ASSEMBLY - REMOVAL).
2. Remove the sunroof motor retaining screws (10) and remove motor (9).
23 - 212
SUNROOF
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст