Dodge Durango (HB). Manual — part 22
3. Place a bearing cap (1) over the cross end (2) and
align cap with yoke bore.
4. Press bearing cap into the yoke bore enough to
clear snap ring groove.
5. Repeat Step 3 and Step 4 to install the opposite
bearing cap.
NOTE: If joint is stiff or binding, strike the yoke
with a soft hammer to seat the needle bearings.
6. Add grease to lube fitting, if equipped.
ASSEMBLY - WITH INJECTED RINGS
NOTE: Replacement joint has internal snap rings.
1. Place joint in flange with one bearing cap.
2. Position press (3) with receiver (1) on flange and
bearing cap (2).
HB
PROPELLER SHAFT
3 - 15
3. Press bearing cap until snap ring groove (1) is
through the flange (2).
4. Install snap ring (2) on bearing (1).
5. Position press (3) with receiver (2) on remaining
bearing cap (1) and flange.
3 - 16
PROPELLER SHAFT
HB
6. Press bearing cap until snap ring groove is through
the flange.
7. Install snap ring (1) on bearing cap (2).
8. Install flange (1) with U-joint in yoke (2).
9. Position press (2) with receiver (1) and lower bear-
ing cap (3) on yoke.
HB
PROPELLER SHAFT
3 - 17
10. Press bearing cap until snap ring groove is
through the yoke.
11. Install snap ring (2) on bearing cap (1).
12. Position press (2) with receiver (3) on remaining
bearing cap (1) and yoke.
3 - 18
PROPELLER SHAFT
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст