Dodge Durango (HB). Manual — part 1199
28. Remove oil pump while pushing in on input shaft
(1).
29. Remove oil pump gasket (2).
CAUTION: By-pass valve must be replaced if
transmission failure occurs.
30. Remove the cooler by-pass valve (1).
HB
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
21 - 201
31. Remove the #1 caged needle bearing (1).
32. Remove the input clutch assembly (1).
33. Remove the #4 thrust plate (2).
21 - 202
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
HB
34. Remove the front sun gear assembly (1) and #4
thrust washer (if still in place).
35. Remove the front carrier/rear annulus (2) and #6
needle bearing (1).
36. Remove the rear sun gear (2) and #7 needle
bearing (1).
HB
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
21 - 203
NOTE: The number seven needle bearing (1) has
three antireversal tabs and is common with the
number five and number two position. The orien-
tation should allow the bearing to seat flat against
the rear sun gear. A small amount of petrolatum
can be used to hold the bearing to the rear sun
gear.
NOTE: Verify that Tool 5058A (1) is centered prop-
erly over the 2/4 clutch retainer (4) before com-
pressing. If necessary, fasten the 5058A bar to the
bellhousing flange with any combination of lock-
ing pliers and bolts to center the tool properly.
37. Install and load Tool 5058A to remove the 2/4
clutch retainer snap ring (3).
NOTE: The 2/4 Clutch Piston has bonded seals
which
are
not
individually
serviceable.
Seal
replacement requires replacement of the piston
assembly.
38. Remove the 2/4 clutch retainer (1).
21 - 204
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст