Dodge Durango (HB). Manual — part 120
C2105-ABS VALVE SUPPLY VOLTAGE CIRCUIT LOW
HB
BRAKES - ABS ELECTRICAL DIAGNOSTICS
5 - 259
C2105-ABS VALVE SUPPLY VOLTAGE CIRCUIT LOW (CONTINUED)
For the ABS circuit diagram (Refer to 5 - BRAKES - SCHEMATICS AND DIAGRAMS).
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
Continuously.
•
Set Condition:
The monitor function test the supply voltage of the valves via the valve feedback lines. If three or more valve
response falts occur simultaneously, a DTC is set.
Possible Causes
LOW VOLTAGE AT THE ABM
ABM INTERNAL
Diagnostic Test
1.
LOW VOLTAGE AT THE ABM
With the scan tool read battery voltage and ignition voltage in the ABM
and compare the two reading to actual battery voltage from a voltme-
ter.
NOTE: Battery must be fully charged.
Are all readings within a half of volt?
Yes
>> Replace the ABM per service information.
Perform ABS VERIFICATION TEST — VER 1.
No
>> Go To 2
5 - 260
BRAKES - ABS ELECTRICAL DIAGNOSTICS
HB
C2105-ABS VALVE SUPPLY VOLTAGE CIRCUIT LOW (CONTINUED)
2.
ABM INTERNAL
Turn key off.
Disconnect the ABM harness connector.
NOTE: Check connector - Clean/repair as necessary.
Turn key on, engine off.
With a test light check (A107) Fused B+, (A111) Fused B+ and (F500)
Fused ignition switch output.
Is test light bright like when connected to the battery?
Yes
>> Replace the ABM per service information.
Perform ABS VERIFICATION TEST — VER 1.
No
>> Repair the high resistance in the circuits.
Perform ABS VERIFICATION TEST — VER 1.
HB
BRAKES - ABS ELECTRICAL DIAGNOSTICS
5 - 261
C2200-ANTI—LOCK BRAKE MODULE INTERNAL
5 - 262
BRAKES - ABS ELECTRICAL DIAGNOSTICS
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст