Dodge Durango (HB). Manual — part 1352
6. Install the new front output shaft rear bearing (2)
with Tool Handle C-4171 (1) and Installer 5066 (3).
INPUT GEAR
1. Align and install the input gear and bearing assem-
bly (1) into the front case. Be sure that the input
gear bearing is fully seated in the front case.
HB
TRANSFER CASE - NV144 - SERVICE INFORMATION
21 - 813
2. Install snap-ring (2) to hold the input gear assembly
(2) into the front case.
3. Install a new input shaft oil seal with Handle
C-4171 and Installer 8841.
MAINSHAFT
1. Lubricate the mainshaft splines with recommended
transmission fluid.
NOTE: Replace the mode hub retainer if the legs
were distorted during removal.
2. Install the mode hub retainer (1) onto the mode
hub (2).
3. Install the mode hub and mode hub retainer (2)
onto the differential assembly (1). Make sure the
retainer is fully seated onto the differential.
21 - 814
TRANSFER CASE - NV144 - SERVICE INFORMATION
HB
4. Install the differential assembly (1) onto the main-
shaft (2).
5. Install the differential snap-ring (1).
6. Install the mainshaft thrust washer (1) onto the
input gear assembly (2).
HB
TRANSFER CASE - NV144 - SERVICE INFORMATION
21 - 815
7. Install the mainshaft and differential assembly (1)
into the input gear (2).
FRONT OUTPUT SHAFT
1. Install the front output shaft (1) into the transfer
case front case.
2. Install the front output shaft retaining ring (2) onto
the output shaft (1).
21 - 816
TRANSFER CASE - NV144 - SERVICE INFORMATION
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст