Dodge Ram Truck 1500-2500-3500. Manual — part 140
INSTALLATION
1. Install differential side bearings (3) with installer
C-4190 (4) and Handle C-4171(1).
2. Install differential case (2) into the housing.
GEAR-PINION/RING
REMOVAL
NOTE: The ring and pinion gears are service as a
matched set. Never replace ring gear without
replacing the matched pinion gear.
1. Remove differential from housing.
2. Place differential case (1) in a vise with soft metal
jaw protectors.
3. Remove bolts holding ring gear to differential case.
4. Drive ring gear (2) from the differential case (1)
with a soft hammer (3).
5. Remove exciter ring from the differential case by
slowly tapping the ring with a brass drift.
3 - 392
REAR AXLE - 248RBI
DR/DH
6. Hold yoke with Yoke Holder 6719A and remove
pinion yoke nut and washer.
7. Remove pinion yoke (2) with Remover C-452 (3)
and Flange Wrench C-3281(1).
8. Remove pinion gear from housing with a soft ham-
mer (1).
DR/DH
REAR AXLE - 248RBI
3 - 393
9. Remove pinion seal with a slide hammer or suit-
able pry bar.
10. Remove oil slinger (1) and front pinion bearing
from housing (2).
11. Remove front pinion bearing cup with Remover
D-158 (1) and Handle C-4171(2).
3 - 394
REAR AXLE - 248RBI
DR/DH
12. Remove rear bearing cup with Remover D-162 (1)
and Handle C-4171 (2).
13. Remove pinion preload shims (1) from pinion
shaft (2).
DR/DH
REAR AXLE - 248RBI
3 - 395
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст