Dodge Ram Truck 1500-2500-3500. Manual — part 1967
7. Connect the drain tubes to the sunroof (1).
8. Adjust the sunroof glass. (Refer to 23 - BODY/
SUNROOF/GLASS PANEL - ADJUSTMENTS)
9. Connect battery negative cable.
10. Install the vehicle headliner, (Refer to 23 - BODY/
INTERIOR/HEADLINER - INSTALLATION).
11. Perform the sunroof position calibration, (Refer to
8 - ELECTRICAL/POWER TOP/MOTOR - STAN-
DARD PROCEDURE - SUNROOF POSITION
CALIBRATION).
12. Perform the Excessive Force Limitation (EFL) cal-
ibration, (Refer to 8 - ELECTRICAL/POWER TOP/
MOTOR
-
STANDARD
PROCEDURE
-
EXCESSIVE FORCE LIMITATION (EFL) CALI-
BRATION).
13. Verify proper operation of the power sunroof
system.
CHANNEL-DRAIN
REMOVAL
1. Remove glass panel (2). (Refer to 23 - BODY/
SUNROOF/GLASS PANEL - REMOVAL)
2. Separate the drain channel arms (2) from the guide
mechanisms (1) one at a time.
CAUTION: Do not pry the channel arms apart at
the same time or you could break the drain
channel.
23 - 222
SUNROOF - SERVICE INFORMATION
DR/DH
3. Carefully slide the drain channel (1) forward to the
notches (2) in the frame and remove from the
vehicle.
INSTALLATION
1. Carefully position the drain channel (1) into the
notches (2) in the frame and slide rearward.
2. Install the drain channel arms (2) into the mecha-
nism (1) holes one at a time with the reinforce-
ments on the inside of mechanism arms.
CAUTION: Do not pry the channel arms apart at
the same time or you could break the drain chan-
nel.
3. Install the sunroof glass. (Refer to 23 - BODY/
SUNROOF/GLASS PANEL - INSTALLATION)
DR/DH
SUNROOF - SERVICE INFORMATION
23 - 223
COVER-GUIDE MECHANISM
REMOVAL
1. Move the glass panel to the full closed position.
2. Slide sunshade rearward to the open position.
3. Separate the mechanism covers (2) from the tabs
(1) on the glass panel.
4. Hold both mechanism covers down and open the
sunroof fully.
5. Slide the mechanism covers (1) out the front of the
guide in the frame (2).
23 - 224
SUNROOF - SERVICE INFORMATION
DR/DH
INSTALLATION
1. With the sunroof in the open position, snap the mechanism cover (2) into the lower guide channel.
2. Hold down each cover and close the sunroof.
3. Snap the upper portion of the cover (2) into the retaining clips (1) on the glass panel between the locating
features.
DEFLECTOR-WIND
REMOVAL
1. Open the sunroof fully.
2. Remove the strap screws (2) from the beam area
release the strap (3).
DR/DH
SUNROOF - SERVICE INFORMATION
23 - 225
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст