Dodge Ram Truck 1500-2500-3500. Manual — part 932
P0585-SPEED CONTROL SWITCH 1/2 CORRELATION (5.7L) (CONTINUED)
11.
S/C SWITCH SIGNAL CIRCUITS SHORTED TO GROUND
Measure the resistance between ground and the (V37) and (V38) S/C
Switch Signal circuits at both Switch harness connectors.
Is the resistance below 100 ohms?
Yes
>> Repair the short to ground in the (V37) or (V38) S/C
Switch Signal circuit.
Perform the POWERTRAIN VERIFICATION TEST. (Refer
to 9 - ENGINE - STANDARD PROCEDURE)
No
>> Go To 12
9 - 650
ENGINE - ELECTRICAL DIAGNOSTICS - 3.7L/4.7L/5.7L
DR/DH
P0585-SPEED CONTROL SWITCH 1/2 CORRELATION (5.7L) (CONTINUED)
12.
SPEED CONTROL SWITCH VOLTAGE VALUES
Allow the engine to idle.
With a scan tool, monitor the S/C Switch voltage readings.
SWITCH POSITION
SWITCH No.1 VOLTAGE VALUE
SWITCH No.2 VOLATGE VALUE
NO SWITCHES PRESSED
4.31 to 4.78 volts
4.31 to 4.78 volts
ON/OFF PRESSED
0.59 to 1.13 volts
3.53 to 3.92 volts
RES/ACCEL PRESSED
3.88 to 4.17 volts
2.04 to 2.47 volts
SET PRESSED
3.16 to 3.56 volts
1.17 to 1.56 volts
COAST PRESSED
2.57 to 2.94 volts
0.77 to 1.09 volts
CANCEL PRESSED
1.59 to 1.99 volts
2.84 to 3.25 volts
DR/DH
ENGINE - ELECTRICAL DIAGNOSTICS - 3.7L/4.7L/5.7L
9 - 651
P0585-SPEED CONTROL SWITCH 1/2 CORRELATION (5.7L) (CONTINUED)
Take these same voltage measurements with a voltmeter by back probing the (V37) S/C Switch No.1 Signal circuit
and the (V38) S/C Switch No.2 Signal circuit at the switches.
Compare the voltage readings on the voltmeter to what the scan tool displayed.
Are the voltage readings out of the listed specification and is there less than a 0.2 of a volt difference
between the voltmeter switch values and the scan tool switch values?
Yes
>> Replace the Speed Control Switch.
Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
No
>> Go To 13
13.
PCM
NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal
push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and
Ground circuits.
Were there any problems found?
Yes
>> Repair as necessary.
Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
No
>> Replace and program the Powertrain Control Module per Service Information.
Perform the POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
9 - 652
ENGINE - ELECTRICAL DIAGNOSTICS - 3.7L/4.7L/5.7L
DR/DH
P0586-SPEED CONTROL VENT CONTROL CIRCUIT
DR/DH
ENGINE - ELECTRICAL DIAGNOSTICS - 3.7L/4.7L/5.7L
9 - 653
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст