Dodge Ram Truck 1500-2500-3500. Manual — part 609
NAVIGATION/TELECOMMUNICATION
TABLE OF CONTENTS
page
page
NAVIGATION/TELECOMMUNICATION -
ELECTRICAL DIAGNOSTICS. . . . . . . . . . . . . . . . . 1
NAVIGATION/TELECOMMUNICATION -
SERVICE INFORMATION . . . . . . . . . . . . . . . . . . 85
NAVIGATION/TELECOMMUNICATION - ELECTRICAL
DIAGNOSTICS
TABLE OF CONTENTS
page
page
NAVIGATION/TELECOMMUNICATION -
ELECTRICAL DIAGNOSTICS
DIAGNOSIS AND TESTING
RECEIVED . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
. . . . . . . . . . . . . . . . . . . 4
BODY STYLE MESSAGE NOT RECEIVED
. . . . . . . . . . . . . . . . . . 7
RECEIVED . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
. . . . . . . . . . . . . . . . . . 16
LEFT AUDIO INPUT SHORT TO GROUND
LEFT AUDIO INPUT SHORT TO VOLTAGE
GROUND . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
VOLTAGE . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
GROUND . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
VOLTAGE . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
. . . . . . . . . . . . . . . . . . . . . . . 41
. . . . . . . . . . . . . . . . 43
PCI BUS CIRCUIT SHORT TO GROUND
PCI BUS CIRCUIT SHORT TO VOLTAGE
. . . . . . . . . . . . . . . . 50
. . . . . . . . . . . . . . . . . . . 54
RIGHT AUDIO INPUT SHORT TO GROUND
RIGHT AUDIO INPUT SHORT TO VOLTAGE
GROUND . . . . . . . . . . . . . . . . . . . . . . . . . . . . 63
VOLTAGE . . . . . . . . . . . . . . . . . . . . . . . . . . . . 67
. . . . . . . . . . . . . . 71
VOICE RECOGNITION SWITCH STUCK
VOICE RECOGNITION/PHONE SWITCH
CIRCUIT RATIONALITY . . . . . . . . . . . . . . . . . 76
VOICE RECOGNITION/PHONE SWITCH
CIRCUIT SHORT TO GROUND . . . . . . . . . . . 78
VOICE RECOGNITION/PHONE SWITCH
CIRCUIT SHORT TO VOLTAGE . . . . . . . . . . . 81
NAVIGATION/TELECOMMUNICATION - ELECTRICAL DIAGNOSTICS
DIAGNOSIS AND TESTING
DR/DH
NAVIGATION/TELECOMMUNICATION
8T - 1
AMP MESSAGE NOT RECEIVED
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
With the ignition on.
•
Set Condition:
The Hands Free Module does not receive the PCI Bus message from the Amplifier.
Possible Causes
LOST COMMUNICATION WITH AMPLIFIER
HANDS FREE MODULE
Diagnostic Test
1.
ATTEMPT TO COMMUNICATE WITH THE AMPLIFIER
Turn the ignition on.
With the DRB, attempt to communicate with the Amplifier.
Was the DRB able to communicate with the Amplifier?
Yes
>> Go To 2
No
>> (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING) and
perform the related symptom.
2.
ERASE DTC AND ATTEMPT TO RESET
With the DRB, erase the HFM DTC’s.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the DRB, read the HFM DTC’s.
Did this DTC reset?
Yes
>> Replace and program the Hands Free Module in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1. (Refer to BODY VERIFICATION TEST - VER 1.)
No
>> The condition that set this DTC is no longer present. Using the wiring diagram/schematic as a guide,
inspect the wiring for chafed, pierced, pinched, and partially broken wires and the wiring harness con-
nectors for broken, bent, pushed out, and corroded terminals.
8T - 2
NAVIGATION/TELECOMMUNICATION - ELECTRICAL DIAGNOSTICS
DR/DH
AUDIO HARDWARE MESSAGE NOT RECEIVED
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
With the ignition on.
•
Set Condition:
The Hands Free Module does not receive the PCI Bus message from the radio indicating what kind of radio
the vehicle is equipped with.
Possible Causes
LOST COMMUNICATION WITH RADIO
HANDS FREE MODULE
Diagnostic Test
1.
ATTEMPT TO COMMUNICATE WITH THE RADIO
Turn the ignition on.
Turn the radio on.
With the DRB, attempt to communicate with the radio.
Was the DRB able to communicate with the radio?
Yes
>> Go To 2
No
>> (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING) and
perform the related symptom.
2.
ERASE DTC AND ATTEMPT TO RESET
With the DRB, erase the HFM DTC’s.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the DRB, read the HFM DTC’s.
Did this DTC reset?
Yes
>> Replace and program the Hands Free Module in accordance with the service information.
Perform BODY VERIFICATION TEST - VER 1. (Refer to BODY VERIFICATION TEST - VER 1.)
No
>> The condition that set this DTC is no longer present. Using the wiring diagram/schematic as a guide,
inspect the wiring for chafed, pierced, pinched, and partially broken wires and the wiring harness con-
nectors for broken, bent, pushed out, and corroded terminals.
DR/DH
NAVIGATION/TELECOMMUNICATION - ELECTRICAL DIAGNOSTICS
8T - 3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст