Dodge Ram Truck 1500-2500-3500. Manual — part 1116
P0699-ACCELERATOR PEDAL POSITION SENSOR (APPS) SUPPLY VOLTAGE TOO
HIGH
9 - 1386
ENGINE - ELECTRICAL DIAGNOSTICS - DIESEL
DR/DH
P0699-ACCELERATOR PEDAL POSITION SENSOR (APPS) SUPPLY VOLTAGE TOO HIGH (CONTINUED)
For the Engine circuit diagram (Refer to 9 - ENGINE - SCHEMATICS AND DIAGRAMS)
For a complete wiring diagram Refer to Section 8W.
•
When Monitored:
While engine is running.
•
Set Condition:
High voltage detected at the APPS supply circuit.
Possible Causes
(F855) 5-VOLT SUPPLY OPEN
(F855) 5-VOLT SUPPLY SHORT TO VOLTAGE
ECM
INTERMITTENT CONDITION
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE -
DIAGNOSIS AND TESTING)
1.
(F855) 5-VOLT SUPPLY OPEN
Turn the ignition off.
Disconnect the APPS harness connector.
NOTE: Check connectors - Clean/repair as necessary.
Ignition on, engine not running.
Measure the voltage between the (F855) APPS #1 5-volt supply circuit
at the sensor connector and battery negative.
Is the voltage between 4.5 and 5.5 volts?
Yes
>> Replace the APPS.
Perform POWERTRAIN VERIFICATION TEST VER - 1
(DIESEL). (Refer to 8 - ELECTRICAL/ELECTRONIC CON-
TROL MODULES/ENGINE CONTROL MODULE - DIAG-
NOSIS AND TESTING)
No
>> Go To 2
DR/DH
ENGINE - ELECTRICAL DIAGNOSTICS - DIESEL
9 - 1387
P0699-ACCELERATOR PEDAL POSITION SENSOR (APPS) SUPPLY VOLTAGE TOO HIGH (CONTINUED)
2.
(F855) 5-VOLT SUPPLY SHORT TO VOLTAGE
Turn the ignition off.
Disconnect the ECM harness connector(s).
NOTE: Check connectors - Clean/repair as necessary.
Ignition on, engine not running.
Measure the voltage between the (F855) APPS #1 5-volt supply circuit
in the sensor harness connector and battery negative.
Is the voltage less than 1 volt?
Yes
>> Go To 3
No
>> Repair or replace the wiring harness.
Perform POWERTRAIN VERIFICATION TEST VER - 1
(DIESEL). (Refer to 8 - ELECTRICAL/ELECTRONIC CON-
TROL MODULES/ENGINE CONTROL MODULE - DIAG-
NOSIS AND TESTING)
3.
ECM
Turn the ignition off.
Reconnect the ECM harness connector(s).
Ignition on, engine not running.
Measure the voltage between the (F855) APPS #1 5-volt supply circuit
at the sensor harness connector and battery negative.
Is the voltage greater than 6 volts?
Yes
>> Replace and program the ECM in accordance with the
Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 1
(DIESEL). (Refer to 8 - ELECTRICAL/ELECTRONIC CON-
TROL MODULES/ENGINE CONTROL MODULE - DIAG-
NOSIS AND TESTING)
No
>> Refer to the INTERMITTENT CONDITION Symptom
(Diagnostic Procedure). (Refer to 9 - ENGINE - DIAGNO-
SIS AND TESTING)
9 - 1388
ENGINE - ELECTRICAL DIAGNOSTICS - DIESEL
DR/DH
P1652-J1850 SHORT TO GROUND
DR/DH
ENGINE - ELECTRICAL DIAGNOSTICS - DIESEL
9 - 1389
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст