Dodge Ram Truck 1500-2500-3500. Manual — part 1948
3. Position the data link connector (3) into the open-
ing in the steering column opening bracket (2) and
fully engage the retaining tabs that secure the con-
nector to the bracket.
4. Install the hood release handle (Refer to 23 -
BODY/HOOD/LATCH RELEASE CABLE - INSTAL-
LATION).
5. Install the steering column opening cover onto the
instrument panel (1) (Refer to 23 - BODY/INSTRU-
MENT
PANEL/STEERING
COLUMN
OPENING
COVER - INSTALLATION).
STORAGE BIN
REMOVAL
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering
wheel, steering column, seat belt tensioner, or instrument panel component diagnosis or service. Discon-
nect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor
to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag
system. Failure to take the proper precautions could result in accidental airbag deployment and possible
personal injury or death.
NOTE: A storage bin replaces the cup holder in
the instrument panel when the vehicle is equipped
with a floor console.
1. Remove the instrument panel center bezel (Refer
to
23
-
BODY/INSTRUMENT PANEL/INSTRU-
MENT PANEL CENTER BEZEL - REMOVAL).
2. Remove the floor console (Refer to 23 - BODY/IN-
TERIOR/FLOOR CONSOLE - REMOVAL).
3. Remove the four screws (1) that secure the stor-
age bin (2) to the instrument panel and remove the
bin.
23 - 146
INSTRUMENT PANEL
DR/DH
INSTALLATION
NOTE: A storage bin replaces the cup holder in
the instrument panel when the vehicle is equipped
with a floor console.
1. Position the storage bin (2) into the instrument
panel.
2. Install the four screws (1) that secure the storage
bin to the instrument panel. Tighten the screws to
2.2 N·m (20 in. lbs.).
3. Install the floor console (Refer to 23 - BODY/INTE-
RIOR/FLOOR CONSOLE - INSTALLATION).
4. Install the instrument panel center bezel (Refer to
23 - BODY/INSTRUMENT PANEL/INSTRUMENT
PANEL CENTER BEZEL - INSTALLATION).
DR/DH
INSTRUMENT PANEL
23 - 147
INTERIOR
TABLE OF CONTENTS
page
page
INTERIOR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 148
4WD FLOOR SHIFT BOOT
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 149
. . . . . . . . . . . . . . . . . . . . . . . . 149
A-PILLAR TRIM/GRAB HANDLE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 150
. . . . . . . . . . . . . . . . . . . . . . . . 151
B-PILLAR GRAB HANDLE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 151
. . . . . . . . . . . . . . . . . . . . . . . . 152
B-PILLAR LOWER TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 152
. . . . . . . . . . . . . . . . . . . . . . . . 153
B-PILLAR UPPER TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 154
. . . . . . . . . . . . . . . . . . . . . . . . 156
C-PILLAR LOWER TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 157
. . . . . . . . . . . . . . . . . . . . . . . . 158
C-PILLAR UPPER TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 158
. . . . . . . . . . . . . . . . . . . . . . . . 159
CARPETS AND FLOOR MATS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 159
. . . . . . . . . . . . . . . . . . . . . . . . 161
COAT HOOK
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 162
. . . . . . . . . . . . . . . . . . . . . . . . 163
COWL TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 163
. . . . . . . . . . . . . . . . . . . . . . . . 164
FLOOR CONSOLE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 164
. . . . . . . . . . . . . . . . . . . . . . . . 165
HEADLINER
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 166
. . . . . . . . . . . . . . . . . . . . . . . . 167
LOAD FLOOR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 167
. . . . . . . . . . . . . . . . . . . . . . . . 168
LOAD FLOOR SUPPORT CYLINDER
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 169
. . . . . . . . . . . . . . . . . . . . . . . . 170
REAR CAB BACK PANEL TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 170
. . . . . . . . . . . . . . . . . . . . . . . . 172
REAR DOOR SILL TRIM COVER
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 173
. . . . . . . . . . . . . . . . . . . . . . . . 173
REAR VIEW MIRROR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 173
. . . . . . . . . . . . . . . . . . . . . . 174
BRACKET . . . . . . . . . . . . . . . . . . . . . . . . . . 174
SUN VISOR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 175
. . . . . . . . . . . . . . . . . . . . . . . . 175
SUN VISOR SUPPORT
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 176
. . . . . . . . . . . . . . . . . . . . . . . . 176
BODY VENT
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 177
. . . . . . . . . . . . . . . . . . . . . . . . 177
INTERIOR
CAUTION
CAUTION:: Do not attempt to remove interior trim panels or moldings without first removing the necessary
adjacent trim panels or moldings. To avoid damaging the trim panels, ensure that all the fasteners are
removed or disengaged before attempting to remove interior trim panels or moldings. Trim panels are
somewhat flexible but can be damaged if handled improperly.
23 - 148
INTERIOR
DR/DH
4WD FLOOR SHIFT BOOT
REMOVAL
1. Using a small flat-bladed tool, remove the insert (2)
from the top of the shift knob (1).
2. Remove the nut (3) that secures the shift knob to
the gear shift lever.
3. Remove the gear shift knob (2).
4. Using a trim stick C-4755 or equivalent, disengage
the retaining tabs that secure the gear shift boot (3)
to the floor console (1) and remove the boot.
INSTALLATION
1. Position the gear shift boot (3) over the gear shift
lever.
2. Engage the retaining tabs that secure the gear shift
boot to the floor console (1).
3. Install the shift knob (2) over the gear shift lever.
DR/DH
INTERIOR
23 - 149
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст