Dodge Ram Truck 1500-2500-3500. Manual — part 1921
INTERIOR HANDLE ACTUATOR
REMOVAL
1. Remove the door trim panel (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - REMOVAL).
2. Position the waterdam out of the way and discon-
nect the actuator rod (3) from interior door handle
actuator (5) and the door latch (2), if necessary.
3. Remove the two nuts (4) that secure the interior
door handle actuator to the door (1) and remove
the actuator.
INSTALLATION
1. Position the interior door handle actuator (5) onto
the door (1).
2. Install the two nuts (4) that secure the interior door
handle actuator to the door. Tighten the nuts to 10
N·m (89 in. lbs.).
3. Connect the actuator rod (3) to the interior door
handle actuator and the door latch (2), if removed.
4. Reposition the waterdam and install the door trim
panel (Refer to 23 - BODY/DOOR - FRONT/TRIM
PANEL - INSTALLATION).
23 - 38
DOOR - FRONT
DR/DH
LATCH
REMOVAL
1. Raise the window to the full up position and
remove the door trim panel (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - REMOVAL).
2. Position the waterdam out of the way and discon-
nect the actuator rod (3) from the door latch (2)
and the interior door handle actuator (5) and
remove the rod.
3. Disconnect the door wire harness connector (2)
from the door latch (3).
4. Remove the three bolts (4) that secure the door
latch to the door (1) and remove the latch.
DR/DH
DOOR - FRONT
23 - 39
INSTALLATION
1. Position the door latch (3) into the door (1).
2. Install the three bolts (4) that secure the door latch
to the door. Tighten the bolts to 10 N·m (89 in.
lbs.).
3. Connect the door wire harness connector (2) to the
door latch.
4. Connect the actuator rod (3) to the door latch (2)
and the interior door handle actuator (5).
5. Reposition the waterdam to the door (1) and install
the door trim panel (Refer to 23 - BODY/DOOR -
FRONT/TRIM PANEL - INSTALLATION).
6. If necessary, adjust the latch (Refer to 23 - BODY/
DOOR - FRONT/LATCH - ADJUSTMENTS).
23 - 40
DOOR - FRONT
DR/DH
ADJUSTMENTS
1. Locate the access hole in the door to adjust the
door latch (1) and remove the mylar tape (2).
2. Loosen the adjustment screw (3).
3. Operate the door handles several times to reduce
any possible linkage binding and tighten the adjust-
ment screw to 3 N·m (30 in. lbs.).
4. Operate the door handles again to verify proper
operation and reinstall the mylar tape.
LATCH STRIKER
REMOVAL
1. Using a grease pencil or equivalent, mark the loca-
tion of the door latch striker (1) on the B-pillar (2).
2. Remove the two bolts (3) that secure the door latch
striker to the B-pillar and remove the striker.
DR/DH
DOOR - FRONT
23 - 41
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст